Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Model No. 12-14NM Features Fastens 12/2, 14/2, 12/3, and 14/3 nonmetallic sheathed cable as well as double-stacked 12/2 and 14/2 nonmetallic sheathed cable to wood framing members Straps will not cut or crush the cables OPERATING INSTRUCTIONS . StrapGun ™ Safety Information WARNING Follow all safety warnings listed below and throughout manual. Improper use of this tool can cause severe injury from flying debris or firing strap into body. 1. Read and understand this manual before loading or using tool. 2. Make certain you read and understand all Warnings. 3. Only well-instructed adults should use tool. Never allow children to use tool. 4. When using tool, keep all body parts away from strap exit. 5. Never point tool at anyone. 6. Wear safety glasses to protect your eyes. 7. Lock handle on tool when loading or not in use. 8. Never use this tool where not intended. For example, don’t use tool on concrete, metal, or glass. 9. Do not alter this tool in any way. 10. Always store tool • with straps removed and handle locked • out of children’s reach 11. Keep this manual for reference. It is your guide to safe and proper operation of this tool. 12. Always disconnect electrical power before fastening cables. Unlocking Handle 1. Hold tool base and handle. Squeeze handle to release tension on handle lock. Slip handle lock off of handle (see Figure 1). 2. Release handle. Handle will spring free. Locking Handle 1. Hold tool firmly (see Figure 2). 2. Pull handle out to release, then push handle down (see Figure 2). 3. While holding handle down, slip handle lock up over handle (see Figure 3). Handle Figure 2 Handle Lock Figure 1 Handle Handle Lock For more information, visit 2 Loading Tool 1. Lock handle (see Locking Handle, page 2). 2. Turn StrapGun™ upside down. At rear of tool, squeeze latch on end of magazine (see Figure 4). Pull rail out of magazine until it stops (see Figure 4). 3. Drop straps into magazine. Make sure insulator is facing up (see Figure 4). 4. Slide rail back into magazine until it locks into place. Operating Tool 1. Unlock handle if locked. 2. Grip tool firmly. Position the wire guide on the front of the tool over the cable. Note: Hold tool flat against work surface (see Figure 5). 3. Depress handle firmly to fire. Do not allow tool to jump or recoil. Note: A better fastening is possible if the thumb or palm of free hand presses firmly against head of tool (see Figure 6). Application Notes 1. Due to the limitations of a manual tool, this product can not drive straps completely into all areas of wood. Avoid knots and dense, high resin areas. 2. If a fastening failure occurs, clear the strap and any material in the front of the magazine completely out. This will significantly reduce the chance of reoccurrence. Figure 3 Handle Handle Lock Straps with Points Facing Up Insulator Magazine Figure 4 Rail Cable Wire Guide Figure 5 Figure 6 For more information, visit 3 STRAP SELECTION GUIDE Use only PowerFast® StrapGun™ Straps which are uniquely designed for this fastening system. Strap No. Application Strap Uses S12-14 Fastens 12/2, 14/2, 12/3, and Residential and commer14/ 3 nonmetallic sheathed cial electrical wiring cable as well as double- stacked 12/2 and 14/2 to wood framing members 12/2, 14/2, 12/3, or 14/3 Nonmetallic Sheathed Electrical Cable Double Stacked 12/2 and 14/2 Nonmetallic Sheathed Electrical Cables S12-14 Insulated Strap LIMITED WARRANTY DESA Specialty Products™ warrants model number 12-14NM for a period of one year from date of purchase against original defects in materials or workmanship. If this product fails to perform for either of those reasons, DESA Specialty Products™ will replace with an equivalent product at no charge within 45 days of receipt of the defective product. This warranty does not cover rental usage. This warranty gives you specific legal rights. You may also have other rights, which vary from state to state. To obtain the benefits of this warranty if the product fails due to defects in materials or workmanship, send sales receipt and product securely packaged and postage prepaid to: Repair Department DESA Specialty Products™ 1430 Ferris Place Bronx, NY 10461-3699 Printed in Taiwan For Technical Assistance call Technical Services Department 1-800-858-8501 You may also visit DESA Specialty Products’™ Technical Services web site at 108056-01 Rev. C 05/03 For more information, visit 4 108056 .. StrapGun™ IMPORTANTE: Para un mejor resultado, sostenga la herramienta en forma plana contra la superficie. Modelo N° 12-14NM Caracteristicas Sujeta el cable con vaina no metalica 12/2, 14/2, 12/3 y 14/3 asi como el cable con vaina no metalica 12/2 y 14/2 de doble hilera a los elementos del bastidor de madera. Las laminas no cortaran ni aplastaran los cables. INSTRUCCIONES DE OPERACION 108056 5 Informacion sobre seguridad ADVERTENCIA Siga todas las advertencias de seguridad listadas a continuacion y a traves del ...