Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
If required use the F-button 4. Voltage supply is too low •Your positioner is still operational, but too low voltage supply can cause an overload 5. Overload exists •If this message appears, check the vehicle‘s voltage (possibly too low), the connection with the positioner, possible icing of the positioner or the positioner is blocked due to an obstacle •Switch off the receiver, then switch it on again (this procedure must be repeated several times, if necessary). Refer in this connection also to point 11 of the user manual for BAS 60, functional disturbances Power-off/Stand-by/Parking position Switch off the receiver with the mains switch (Power-off) The receiver is separated from the mains, the control unit automatically switches to the stand-by mode, and the HDP remains in its satellite position until the receiver is switched on again. Stand-by Pressing the stand-by button once, switches receiver and control box to the stand-by mode. The HDP behaves the same as in mode „Power-Off“ (see above). Parking position Pressing the stand-by button twice causes the HDP to move automatically into the parking position, whereas the control unit and the receiver swith to stand-by mode. After the receiver is switched on again, the HDP moves to its last satellite position. More detailed information as to moving the HDP into the parking position is found in the unabridged manual. 936.2412/2.2e/ZWT - Technical ...
Эта инструкция также подходит к моделям:Спутниковые ресиверы - 300/HDP 170 (783.68 kb)
Спутниковые ресиверы - CAP 200 (783.68 kb)
Спутниковые ресиверы - HDP 170 (783.68 kb)