Оценок - 3, средний балл: 4.3 ( )

Производитель: Kathrein Размер: 783.68 kb Название файла: 9362412b.pdf Язык инструкции:

HOTBIRD). No signal! Signal 7. After this, the following insertion will appear partial picture appears above at right. and after another few seconds the desired TV programme is shown as full picture: 6. If the satellite signal is found, at first only a small Do not stop the search now, since the receiver undertakes a fine tuning in order to optimize signal reception! (This procedure may last up to two minutes depending on the reception situation) 936.2412/ZWT Note: The F-button of your remote control unit allows you at almost any time to start a satellite search (Exceptions: You have called up a menu or a different OSD is already shown). Furthermore, the search will not start if you already have a TV signal. After having pressed the F-button, the present satellite position is approached; if there is no signal, the OSD for point 5 will appear. Then continue the procedure as mentioned under point 5. CAP 200 and 300/HDP 170 Short User Guide Possible fault messages and their causes 1. Initalisation OSD does not disappear (not even after 20 seconds) • Check the connection between receiver and control unit • Control in the main menu if the HDP mode (antenna positioning) on the receiver was switched off 2. Satellite could not be found • Try the search once more but with a different programme of the same satellite • The OK-button allows you to exit from the OSD insertion and the search fo a new programme. If required, use the F button 3. The satellite signal was lost (e.g. possibly due to unfavourable reception conditions) •Repeat the search with the same or a different programme of the same satellite • Pressing the OK-button allows exit from the OSD insertion and the selection of a new programme. If required use the F-button 4. Voltage supply is too low •Your positioner is still operational, but too low voltage supply can cause an overload 5. Overload exists •If this message appears, check the vehicle‘s voltage (possibly too low), the connection with the positioner, possible icing of the positioner or the positioner is blocked due to an obstacle •Switch off the receiver, then switch it on again (this procedure must be repeated several times, if necessary). Refer in this connection also to point 11 of the user manual for BAS 60, functional disturbances Power-off/Stand-by/Parking position Switch off the receiver with the mains switch (Power-off) The receiver is separated from the mains, the control unit automatically switches to the stand-by mode, and the HDP remains in its satellite position until the receiver is switched on again. Stand-by Pressing the stand-by button once, switches receiver and control box to the stand-by mode. The HDP behaves the same as in mode „Power-Off“ (see above). Parking position Pressing the stand-by button twice causes the HDP to move automatically into the parking position, whereas the control unit and the receiver swith to stand-by mode. After the receiver is switched on again, the HDP moves to its last satellite position. ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: