Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
**Programmable for . second press or double press. This option is 7 selectable by your installer. TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the EZEESTART system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expensive turbo timers. This mode requires the use of an extra part called a momentary switch/button that is not included with the kit. Check with your installer about adding this feature. NOTE: The turbo timer button will also trigger a remote start if it is inadvertently pressed when the vehicle is not running. Please note this when installing the button and choose a location out of harm’s way. 1) Engine should be running with the key. 2) Press and hold down the brake pedal. 3) Press your “Turbo Timer” button 1 to 5 times for each minute of run time you desire. (1 press = 1 min.) 4) As you release the brake pedal and your system will confirm by flashing the lights the same number of times the button was pressed. 5) Turn Ignition switch OFF, remove key and exit the vehicle. Remote lock your doors for safety. The engine should remain running for the selected number of minutes. 8 PRESS TURBO PRESS AND HOLD TIMER BUTTON 1-5 TIMES RUNNING RELEASE BRAKE PRESS TURBO PRESS AND HOLD TIMER BUTTON 1-5 TIMES RUNNING RELEASE BRAKE BRAKE REMOVE KEY FLASH 1-5X LIGHTS RUNNING REMAIN EXIT VEH. 1-5 MIN. CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install. Press the Lock or Unlock transmitter button as you leave or come near the vehicle. Parking lights will flash once for lock and twice for unlock. If vehicle is running by the remote start system, the lights will flash, but return back to solid. AUTO LOCK/UNLOCK (Improved) The Auto Lock feature controls whether the doors will automatically lock/unlock on your vehicle when driving or with turning the Ignition ON/OFF. If the Auto Lock feature is turned on, and your system is in “Tach” mode, then the doors should automatically lock as the engine RPM increase (driving). If the Auto Lock feature is turned on, and your system is in “Smart Tachless” mode, then the doors will lock a few seconds after the Ignition is turned on. When the Auto Lock feature is turned on, the system will always unlock the doors when the Ignition is turned off. With this feature turned OFF, the system will not automatically lock or unlock the vehicle. See your installer for programming information on this feature. DOOR LOCK NOTE: If your system has been setup with an optional starter kill relay, but you do not have power door locks, note the following: The lock and unlock buttons on the remote control must still be utilized to operate the Starter disable. 9 REMOTE PANIC (Used only with Optional HORN HONK feature installation) For personal safety this unit now includes a panic feature. To sound the vehicle car horn, press the Lock Button on the remote for more than 2 seconds. The vehicle horn will honk along with flashing parking lamps for 1 minute. Reset Remote Panic by pressing either the lock or unlock button. See next section for Horn Honk information. HORN CHIRP/HONK OUTPUT (Optional: with Horn connection & programming) This feature, if installed, will provide audible confirmation chirps from the factory horn for lock and unlock. When using this feature, pressing the Lock/Unlock button a 2nd time within 3-7 seconds or single press lock/unlock will provide a horn chirp for audible confirmation. The system can also be programmed to provide 3 chirps when a remote start is requested using the remote. Note: Horn honk/chirp feature may require extra labor and/or parts to install. REMOTE TRUNK RELEASE OR DOMELIGHT ILLUMINATION (Optional) This EZEESTART system includes an output that can be programmed to remotely release a factory electronic trunk or illuminate the interior light when you unlock your vehicle for lighted entry at night. If you have the optional trunk pop installed, simply press and release the Trunk Button #3 on the transmitter or if option # 6 is turned on you must press Button # 3 twice within 3 seconds, to remotely open trunk. If your system is programmed for Dome Light illumination, then it will work automatically lighting the dome light for 30 seconds when you unlock your vehicle via the remote. The dome light will turn off after 30 seconds, or turning the key on (whichever comes first). The trunk Pop or Dome Light Illumination may require extra labor and/or parts to install. CONVENIENCE AND SAFETY FEATURES VALET MODE / STARTER DISABLE OVERRIDE Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The ...
Эта инструкция также подходит к моделям:Сотовые телефоны - EZEE START EZ-55DP (246.15 kb)