Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
If done, the flywheel may shatter during operation. Do not tamper with links or other parts to increase engine speed. Regular maintenance improves performance and extends engine life. More frequent service is required when operating in adverse conditions. See any authorized service dealer for correct replacement parts. Other parts may not perform as well, may damage the engine, result in injury, or void your warranty. Inspect / Change Spark Plug (^Fig. 7^) Annually or every 50 hours of use inspect the spark plug. 1. Clean the spark plug with a wire brush removing the carbon buildup. Check the condition of the plug for cracking or damage. Replace as necessary. 2. Set the spark plug gap to .030 in. (0.75 mm). O 3. Install the spark plug finger tight, then torque to 175 in-lbs. TROUBLESHOOTING Engine will not start Out of fuel • Prime engine • If engine is cold, ensure choke is set correctly. • Add fuel Bad or stale fuel • Drain the fuel tank and the float bowl of the carburetor. Fill the tank with clean fresh, properly mixed fuel. Call or see an authorized service dealer if you need help. Engine flooded • Spark plug maybe fouled. Fouled spark plug / engine fails to product spark • Remove spark plug and clean it. Check the spacing on the electrode and set the gap to the correct dimension. See Maintenance Section. If plug is damaged, replace with a new spark plug. • Ensure the spark plug is installed and wire is connected. Engine runs rough Engine smokes excessively (some smoke is normal) • There maybe slight oil accumulation in the crankcase upon starting. This is normal. • If excessive smoke or smoke is heavy, ensure choke is in OFF position. • Fuel is too rich. Drain fuel tank and fill with correct gasoline/oil mixture. Engine lacks power or back fires • Check for bad or stale fuel. • The exhaust system maybe clogged. See an authorized service dealer for assistance. STORAGE ik WARNING Store in a clean, dry area. DO NOT store near a stove, furnace or water heater which uses a pilot light or any device that can create a spark. Engines stored over 30 days need to be protected or drained of fuel to prevent gum from forming in fuel system or on essential carburetor parts. 1. Add a fuel stabilizer/conditioner to the fuel in the fuel tank as directed. 2. Run the engine for 5 minutes to distribute the conditioned fuel through the fuel system. 3. Stop the engine and allow it to cool. 4. Use a hand pump to pump the fuel from the fuel tank into an approved fuel container, or run the engine until it stops. 5. Start the engine and run it until it stops. 6. Choke or prime the engine, start it a third time, and run the engine until it will not start. 7. Slowly pull the recoil starter until you feel resistance due to compression pressure, then stop. 8. Release the starter tension gradually by allowing the rope to go back slowly to prevent engine from reversing due to compression pressure. 9. Dispose of unused fuel properly. Recycle it according to local codes, or use it in your automobile. 801254 . 19368 Spark plug wrench .......................... 89838 -or- 5023 To purchase, or view other products Briggs & Stratton has available, see an Authorized Briggs & Stratton Service Dealer. Use our web site at to find a dealer nearest you, or check the “Yellow Pages™”. Walking fingers logo and “Yellow Pages” are registered trademarks in various jurisdictions. ™ Need Assistance? Go to the website or call, 1-800-233-3723, (U.S.A. and Canada) to hear a menu of pre-recorded messages offering engine maintenance information. TECHNICAL INFORMATION Power Ratings The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002-05). Given both the wide array of products on which our engines are placed, and the variety of environmental issues applicable to operating the equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a piece of power equipment (actual “on-site” power). This difference is due to a variety of factors including, but not limited to, the following: differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication, maximum governed engine speed, individual engine to engine variability, design of the particular piece of power equipment, the manner in which the engine is operated, engine run-in to reduce friction and clean out of combustion chambers, adjustments to the valves and carburetor, and other factors. The power ratings may also be adjusted based on comparisons to other similar engines utilized in similar applications, and will therefore not necessarily match the values derived using the foregoing codes. SERVICE Partial List of Engine Parts Spark plug ........... Spark tester .......... ft 4 Briggs & Stratton Corporation (B&S)...
Эта инструкция также подходит к моделям:Снегоочистители - 84200 (670.77 kb)
Снегоочистители - 84100 (670.77 kb)