Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
This engine is certified to operate on unleaded gasoline intended for automotive use with an octane rating of 87 ([R + M] / 2) or higher. Do not use automotive oil or 2-cycle outboard oil. NOTE: Premium Exact Mix™ fuel mixture will stay fresh up to 30 days. DO NOT mix quantities larger than usable in a 30 day period. PREMIUM EXACT MIX™ (50:1) GASOLINE OIL 1 Gallon (US) 2.6 oz. 1 Liter 20 cc (20 ml) FILLING THE TANK WARNING: Always stop the engine before filling the fuel tank. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. (9 m) from the refueling area before starting engine. Do not smoke while filling the tank. ¦ ¦¦¦¦¦Clean the surface around the fuel cap to prevent contamination. ¦ ¦¦¦¦¦Loosen the fuel cap slowly, by turning it counterclockwise. ¦ ¦¦¦¦¦Pour the fuel mixture carefully into the tank. ¦ ¦¦¦¦¦Clean and inspect the fuel cap gasket before replacing the fuel cap. ¦ ¦¦¦¦¦Replace the fuel cap and tighten it by turning it clockwise. ¦ ¦¦¦¦¦Wipe spilled fuel from the product. ¦ ¦¦¦¦¦Move at least 30 ft. (9 m) away from refueling area before starting the product. NOTE: It is normal for smoke to be emitted from a new engine during first use. WARNING: Check for fuel leaks. If you find any leaks, correct the problem before using the product. Failure to do so could result in a fire that could cause serious personal injury. WARNING: A leaking fuel cap is a fire hazard and must be replaced immediately. Failure to do so could result in a fire that could cause serious personal injury. Page 10 OPERATION STARTING AND STOPPING See Figures 8 - 9. TO START: ¦ ¦¦¦¦¦Place the blower on a flat bare surface. ¦ ¦¦¦¦¦Set switch to ON (I). ¦ ¦¦¦¦¦Squeeze the throttle trigger fully and hold. Press trigger lock lever down and release throttle trigger. ¦ ¦¦¦¦¦Slowly press the primer bulb seven (7) times. ¦ ¦¦¦¦¦Move the choke lever to the FULL CHOKE position. ¦ ¦¦¦¦¦Pull the starter handle sharply until engine attempts to run. Do not pull the starter handle more than eight (8) times. ¦ ¦¦¦¦¦Move the choke lever to the HALF CHOKE position. ¦ ¦¦¦¦¦Pull the starter handle until the engine runs. Do not pull the starter handle more than six (6) times. ¦ ¦¦¦¦¦Allow the engine to run 15 seconds, then set the choke lever to the RUN position. Squeeze the throttle trigger to release the trigger lock. TO STOP: Set the switch to OFF (O). TO REMOVE BLOWER: ¦ ¦¦¦¦¦Move harness straps off the shoulders, let straps slide down arms. ¦ ¦¦¦¦¦Grasp the straps and lower the blower to the ground. WARNING Do not allow familiarity with your product to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. OPERATING THE BLOWER See Figure 10. ¦ Start the blower, refer to “Starting and Stopping” later in this manual. Slip arm through harness strap and onto shoulder, then repeat for the other shoulder. Adjust the straps to a comfortable position, refer to “Adjusting Harness Straps” earlier in this manual. Operate the blower from the right side as shown in illustration. ¦ To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile. ¦ To reduce sound levels, limit the number of pieces of equipment used at any one time. ¦ Operate blower at the lowest possible throttle speed to do the job. ¦ Check your equipment before operation, especially the muffler, air intakes and air filters. ¦ Use rakes and brooms to loosen debris before blowing. Fig. 10 AIRFILTERAIRFILTER Fig. 8 TRIGGER LOCK THROTTLE TRIGGER Fig. 9 PRIMER BULB CHOKE LEVER FULL CHOKE RUN SWITCH SWITCH HALF CHOKE Page 11 Page 12 OPERATION MAINTENANCE WARNING: When servicing use only identical manufacturer's replacement parts. Use of any other parts may create a hazard or cause product damage. REPLACING AND CLEANING THE AIR FILTER See Figure 11. For proper performance and long life, keep air filter clean. ¦ Pivot the air filter cover down by pushing down on the latch with your thumb while gently pulling on the cover. ¦ Remove the filter. Clean it in warm soapy water. Rinse and let dry completely. For best performance, replace annually. ¦ Install the filter. Pivot the cover into place ensuring the latch snaps and latches into place. Fig. 11 AIR FILTER BASE AIR FILTER COVER ¦ In dusty conditions, slightly dampen surfaces when water is available. ¦ Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches and gardens. ¦ Watch out for children, pets, open windows or freshly washed cars, and blow debris safely away. ¦ Use the nozzle for larger volume, so the air stream can work close to the ground. ¦ After using blowers or other equipment, CLEAN UP! Dispose of debris properly. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal...
Эта инструкция также подходит к моделям:Системы вентиляции - BACKPACKER II UT08570 (1.2 mb)