Войти:
Оценок - 2, средний балл: 5 ( )

Инструкция по эксплуатации Shindaiwa, модель 68907-94311

Производитель: Shindaiwa
Размер: 3.9 mb
Название файла: 8abaa932-3b88-4501-a5f2-384dd8797f9a.pdf
Язык инструкции:enfr
Перейти к скачиванию



Фрагмент инструкции


NEVER place flammable material close to the engine muffler. NEVER run the engine without the spark arrester screen in place. Stay Alert You must be physically and mentally fit to operate this unit safely. WARNING! Never make unauthorized modifications or attachment installations. Never use attachments not approved by Shindaiwa for use on this unit. WARNING! Never operate power equipment of any kind if you are tired or if you are under the influence of alcohol, drugs, medication or any other substance that could affect your ability or judgement. The Properly Equipped Operator Always wear eye protection such as a face shield or goggles while operating this unit. Never operate the blower when visibility is poor. Wear hearing protection when operating this unit. Wear a dust mask to reduce the risk of inhalation injuries. Wear close-fitting clothing to protect legs and arms. Gloves offer added protection and are strongly recommended. Do not wear clothing or jewelry that could get caught in machinery or underbrush. Secure hair so it is above shoulder level. NEVER wear shorts! Keep a proper footing and do not overreach. Maintain your balance at all times during operation. Always be aware of the strength and direction of the blower discharge stream. Never direct the blower discharge stream toward people or animals! Wear appropriate footwear such as non-skid boots or shoes. Do not wear open-toed shoes or sandals and never operate the unit while barefoot! Figure 1 Be Aware of the Working Environment Reduce the risk of bystanders being struck by flying debris. Make sure no one is within 15 m (50 feet)—that’s about 16 paces—of an operating blower. Avoid long-term operation in very hot or very cold weather. Make sure bystanders or observers outside the 15 m (50 feet) “danger zone” wear eye protection. 15 METERS Never operate the blower if any component parts are damaged, loose, or missing! Do not direct the air blast towards bystanders. The high air flow could blow small objects at great speed causing possible eye injury. Be extremely careful of slippery terrain, especially during rainy weather. Never operate this blower on a roof, ledge or ladder. Be constantly alert for objects and debris that could be thrown from the air blast and bounced from a hard surface. Figure 2 Assembling the Blower Push the nozzle over the blower tube and locking pin Blower Tube Push the blower tube over the discharge port and locking pin WARNING! Danger from rotating impeller! Stop the engine before installing or removing the blower tubes! Never perform any maintenance or assembly procedures on this unit while the engine is running! Locking Pin Locking Pin Blower Tube 1 3 Nozzle Rotate clockwise to lock Rotate clockwise to lock Mark “THIS SIDE UP” must face up 2 4 3. Grasp the nozzle with the mark “THIS SIDE UP” positioned as shown, and then push the nozzle over the straight tube and locking pins. 4. Lock the nozzle to the straight tube by rotating the nozzle as shown. Place the blower upright on the ground or on a sturdy work surface. 1. Grasp the blower tube as shown, and push the tube over the blower discharge port and locking pins. 2. Lock the blower tube to the blower discharge port by rotating the tube as shown. IMPORTANT! Blower tube installation affects both blower balance and performance! The tube and nozzle are correctly installed when the mark “THIS SIDE UP” is visible to the operator during normal operation. Mixing Fuel CAUTION! Some gasolines contain alcohol as an oxygenate! Oxygenated fuels may cause increased operating temperatures. Under certain conditions, alcohol-based fuels may also reduce the lubricating qualities of some mixing oils. Never use any fuel containing more than 10% alcohol by volume! Generic oils and some outboard motor oils may not be intended for use in high-performance air cooled 2-cycle engines, and should never be used in your Shindaiwa engine! CAUTION! This engine is designed to operate on a 50:1 mixture consisting of unleaded gasoline and a premium 2-cycle mixing oil only. Use of non-approved mixing oils can lead to excessive maintenance costs and/or engine damage. WARNING! Minimize the risk of fire! n STOP the engine before refueling. n ALWAYS allow the unit to cool before refueling! n ALWAYS store gasoline in a container approved for flammable liquids. n Wipe all spilled fuel and move the unit at least 3 m (10 feet) from the fueling point before restarting! n NEVER start or operate this unit if there is a fuel leak. n NEVER start or operate this unit if the carburetor, fuel lines, fuel tank and/or fuel tank cap are damaged. n NEVER smoke or light any fires near the unit or fuels! n NEVER place any flammable material near the engine muffler! n NEVER operate the engine without the muffler and spark arrester in place and properly functioning! n Use only fresh, clean unleaded gasoline with a pump octane rating of 87 or higher. n Mix gasoline with 50:1 Shindaiwa Premium 2-cycle mixing oil or with an equiv...

Эта инструкция также подходит к моделям:
Системы вентиляции - EB2510 (3.9 mb)
Системы вентиляции - EB2510/EVC (3.9 mb)
Системы вентиляции - EB3410 (3.9 mb)
Системы вентиляции - EB3410/EVC (3.9 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории