Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
Experiment until you find the best position for your needs. For best performance, be sure engine recoil starter assembly, the blower intake and outlet areas are always kept clear and free of leaves or other debris. Maintenance Instructions Keep all nuts, bolts, and screws tight. Never store the blower with fuel in its fuel tank inside a building or in a confined space where fumes may reach an open flame or sparks. Always refer to the instruction manual for important details if the product is to be stored for an extended period. Engine - 4 cycle. (Refer to engine manufacturer’s operating instructions for fuel recommendations and additional information.) Tires - Tubeless. Inflate to air pressure of 30 P.S.I. Labels should be inspected before each use. Replace damaged labels immediately. Check oil level regularly Be sure correct oil level is maintained. Check oil level after every 5 hours of operation, or daily, before starting engine. Use SAE 30 oil. Change oil after first 5 hours of operation. Remove drain plug and drain oil while engine is warm. Replace drain plug. Remove oil fill plug and refill with new oil. Start and run engine at idle for 30 seconds. Stop engine. Wait 30 seconds and re-check oil level. If required, add oil to overflowing at oil fill plug. TO PREVENT ACCIDENTAL STARTING, REMOVE SPARK PLUG WIRE WHEN SERVICING ENGINE OR EQUIPMENT. OPERATION NOTES TORQUE SPECIFICATIONS Location Description P/N Min. Torque Ft-lbs (In-lbs) Max. Torque Ft-lbs (In-lbs) Housing to engine face BLT-W LF 5/16-24 x 3/4 910503 22 (264) 28 (336) Deck to housing NUT 5/16-18 64141-6 16 (192) 22 (276) Engine to deck BLT 5/16-18 X 1-1/2 64262-009 19 (228) 25 (300) Lower handle to deck BLT 5/16-18 X 1-3/4 64123-61 19 (228) 25 (300) Upper handle to lower handle BLT 5/16-18 X 1-3/4 64123-61 19 (228) 25 (300) Thrrotle to handle BLT 1/4-20 X 1-3/4 90-0414 4 (48) 6 (72) Interior deflector to hook BLT-W LF 10-32 X 5/8 64139-26 (52) (71) Fan to Crankshaft (8HP LB800) BLT 3/8-24 X 2.0 GR8 64123-126 30 50 Fan to Crankshaft (9HP LB900) BLT 7/16-20 X 2.0 GR8 64123-183 50 90 Front panel to housing (short stud) NUT 5/16-18 64141-6 16 (192) 22 (276) Intake guard clamp (long stud) NUT-NYLOC 5/16-18 64229-02 8 (100) Wheel bracket to housing NUT-FL 5/16-18 64141-6 16 (192) 22 (276) Front wheel axle bolt BLT 3/8-16 X 5-1/2 GR5 64123-252 34 45 OPTIMAX BLOWER 12 INTAKE GUARD ASSY FIGURE 1 OPTIMAX BLOWER EN ITEM PART NO. DESCRIPTION QTY ITEM PART NO. DESCRIPTION QTY 13 INTAKE GUARD ASSY FIGURE 1 1-1 910648 LABEL-INTAKE GUARD 1 1-2 64229-02 LOCKNUT-NYL 5/16-18 3 1-3 911130 CLAMP-INTAKE GUARD 3 1-4 921101.7 ASSY-INTAKE GUARD 1 1-5 64141-6 NUT 5/16-18 3 1-6 921121.10 FRONT PANEL 1 1-7 64123-183 BLT-HEX 7/16-20X2.0 GR8 1 1-8 910220 FAN-9HP 1 1-9 64164-13 KEY, 1/4X1/4X2 1 1-10 910528 WASHER,HUB 9HP 1 ENGINE ASSY FIGURE 2 ENGINE ASSY FIGURE 2 2-1 64229-02 LOCKNUT-NYL 5/16-18 8 2-2 64141-6 NUT 5/16-18 4 2-3 4163471 ENGINE-9HP SUBARU 1 2-4 946 CLIP-THROTTLE 1 2-5 4163481 CABLE-THROTTLE 1 2-6 900301.10 HANDLE-UPPER 1 2-7 900303 GRIP 2 2-8 90-0414 BLT-1/4-20 X 1-3/4 1 2-9 64197-023 SCREW-10-32 X 3/4 SLF TP 1 2-10 64151-8 LOCKNUT-1/4-20 2-WAY 1 2-11 920300 WHEEL 2 2-12 600562 RETAINING RING 2 2-13 64163-16 WASHER-5/8 FLAT 2 2-14 910205 AXLE 1 2-15 916-2.10 HANDLE-LOWER 2 2-16 64163-55 WASHER-5/16 FLAT 12 2-17 920031.7 DECK-9HP RT 1 2-18 920029.7 DECK-9HP LFT 1 2-19 64123-61 BLT-HEX 5/16-18X1-3/4 8 2-20 934B BEARING-WHL 4 2-21 64268-02 NUT-FL NYLON LOCK 5/16-18 4 2-22 64262-009 BLT-FLGHD 5/16-18X1-1/2 4 HOUSING ASSY FIGURE 3 HOUSING ASSY FIGURE 3 3-1 64141-6 NUT 5/16-18 3 3-2 910041.10 HOUSING-9HP 1 3-3 910647 LABEL-LW HOUSING 9HP 1 3-4 910609 LABEL-WARNING 1 3-5 910503 BLT-WLF 5/16-24 X 3/4 4 3-6 64151-31 LOCKNUT-10-32 7 3-7 910130 SPRING-DEFLECTOR 1 3-8 8-18 RING-RETAINING 3 3-9 910131 KNOB 1 3-10 64002-04 LOCKWASHER-5/16 1 3-11 910121.10 DEFLECTOR-9HP SIDE 1 3-12 64139-26 BLT-WLF 10-32 X 5/8 2 3-13 910123.10 DEFLECTOR-9HP INT 1 3-14 910132 HANDLE-DEFLECTOR 1 3-15 64151-18 LOCKNUT-3/8-16 2-WAY 1 3-16 64123-252 BLT-HEX 3/8-16 X 5-1/2 1 3-17 910403.10 BRKT-FRT WHL 1 3-18 934 WHEEL-PNEUMATIC 1 3-19 900404 SLEEVE-WHEEL 1 3-20 900405 SPACER-FRT WHL BRKT 2 3-21 934B BRG-PNEUMATIC WHL 2 3-22 64152-68 SCREW 10-32X5-1/2 HH 5 5 year limited service & warranty policy for gasoline powered MAXIMUM output blowers All Little Wonder Gasoline Powered Maximum Output blowers are guaranteed against defects in material and workmanship for a period of FIVE YEARS from date of purchase, when used for RESIDENTIAL SERVICE, or COMMERCIAL SERVICE. Any Little Wonder Gasoline powered Maximum Output Blower or part found to be defective within the warranty period is to be returned to any registered Little Wonder dealer. Engines for all gasoline powered products are warranted separately by the engine manufacture. Therefore, there are no warranties made, expressed or implied, for engines for gasoline powered products by Little Wonder. Transportation charges for parts and units submitted...
Эта инструкция также подходит к моделям:Системы вентиляции - MAN 4163480 (2.57 mb)