Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
In addition, the cutting board is printed with V2“ grid lines (#2), which acts as an excellent visual aid in achieving a straight T-square cut. • Insert the material to be cut under the clamp/safety guard (#3). • Align material at desired position on inch/cm scale (#1). Material should be flush with paperstop (#4), and parallel to the printed grid lines (#2). • Depress the material to be cut with the clamp. The clamp will secure the material in position, preventing slippage. While clamping the material, lower the blade, pressing the blade gently toward the cutting board, thereby ensuring that a consistent, smooth cut is attained even with the thinnest types of paper. MAINTENANCE Blade - The blade should never descend by itself. If it moves too easily, it can be adjusted with the bolt assembly located at the fulcrum (#9). In order to do so, remove the screw (#5) first and take off the lid (#6). Then tighten the hex nut (#7) and the screw (#8) in a counter-action, thus adjusting the pressure of the upper blade against the lower one. At last put the lid back on and secure with the screw. Cutting Board Surface - The cutting board should be cleaned periodically, or as often as required, in order to retain it’s original lustre. A mild general household cleaner is recommended. LUBRICATION The blades of your Dahle cutter were lubricated at the factory and do not require any additional treatment. Do Not lubricate the cutting blades. CAUTION • Keep fingers clear of cutting blades. • Do not lubricate the cutting blades. • Keep out of reach of children. • Keep handle in down position when not in use and when moving or transporting. a bcoffice (800) 658-8788 12112.90.1830 - 7/00...
Эта инструкция также подходит к моделям:Шредеры - 112 (149.29 kb)
Шредеры - 118 (149.29 kb)
Шредеры - 124 (149.29 kb)