2 OF SERVICE MANUAL AC0201 Illustrated Parts List Model Series Briggs & Stratton® AC0201 POWER PRODUCTS 3” Water Pump PRINTED IN U.S.A. COPYRIGHT by BRIGGS & STRATTON CORPORATION All rights reserved. No part of this material may be reproduced or transmitted, in any form or by any means, electronic or mechanical, including photocopying, recording or by any information storage and retrieval system, without permission in writing from Briggs & Stratton Corporation. AC0201 5507-2 Assemblie

2 OF SERVICE MANUAL AC0101 Illustrated Parts List Model Series Briggs & StraMon• AC0101 POWER PRODUCTS 2” Water Pump PRINTED IN U.S.A. COPYRIGHT by BRIGGS & STRATTON CORPORATION All rights reserved. No part of this material may be reproduced or transmitted, in any form or by any means, electronic or mechanical, including photocopying, recording or by any information storage and retrieval system, without permission in writing from Briggs & Stratton Corporation. AC0101 5436-2 Assemblies

197988D Revision D (04/24/2007) EXPLODED VIEW EXPLODED VIEW - MAIN UNIT Copyright © 2007 Briggs & Stratton Power Products Group, LLC. All rights reserved. No part of this material may be reproduced or transmitted in any form by any means without the express written permission of Briggs & Stratton Power Products Group, LLC. 2 PARTS LIST PARTS LIST - MAIN UNIT Item Part # 1 865159GS 3 197755GS 4 198678GS 5 198057GS 6 * 7 * 8 * 9 * 10 197753GS 11 197759GS 12 198155GS 13 198675GS

5041.) 4. Parts which are scored or broken because an engine was operated with insufficient or contaminated lubricating oil, or an incorrect grade of lubricating oil (check oil level daily or after every 8 hours of operation. Refill when necessary and change at recommended intervals.) OIL GARD. may not shut down running engine. Engine damage may occur if oil level is not properly maintained. Read Operating & Maintenance Instructions. 5. Repair or adjustment of associated parts or assemblies such

HAZARD SYMBOLS AND MEANINGS Fire Moving Parts Shock Explosion Toxic Fumes Hot Surface Kickback WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. * Briggs & Stratton does not necessarily know what equipment this engine will power. For that reason, you should carefully read and understand the operating instructions for the equipment on which your engine is placed. 3 SAFETY SAFETY WARNING Gaso

• Keep oil level at FULL. • Check level daily, or after every eight (8) hours. • Do not overfill. Oil checking procedure: before starting engine, check oil level. [1] Place engine level. Clean around oil fill and dipstick. [2] Remove dipstick and wipe clean with cloth. Oil Fill IIIII II [3] Tighten dipstick down. Remove & check oil level. Oil filling procedure: first add 1 quart (32 ounces or 1 liter). Start and run engine at idle for 30 seconds. Shut engine off and wait 30 seconds. Then add mor

Pre-cleaner To clean pre-cleaner (if equipped), separate it from cartridge and wash in liquid detergent and water. Squeeze dry in a clean cloth. Saturate in engine oil. Squeeze in clean, absorbent cloth to remove all EXCESS oil. Cartridge To clean cartridge, gently tap on a flat surface. REMOVING AND INSTALLING AIR CLEANER FOAM BODY Dual element air cleaner COVER CARTRIDGE PART NO. 394018 PRE-CLEANER PART NO. 272490 CLIPS PRE-CLEANER and CARTRIDGE PART NO. 5050 IIIPLATE KNOB [1] Unhook clips on

per min.) to prolong starter life. Extended cranking can damage starter motor. STOPPING Fig. 3 Do not move choke control to CHOKE position to stop engine. Backfire or engine damage may occur. Move throttle control . to IDLE or SLOW position, if equipped. Then turn key . to OFF. or move stop control to OFF position. Close fuel shut-off valve . Note: Always remove key from switch when equipment is not in use or left unattended. Note: When engine is transported, close fuel shut-off valve to prevent

Look For Relevant Emissions Durability Period and Air Index Information On Your Engine Emissions Label Engines that are certified to meet the California Air Resources Board (CARB) Tier 2 Emissions Standards must display information regarding the Emissions Durability Period and the Air Index. Briggs & Stratton makes this information available to the consumer on our emissions labels. The engine emissions label will indicate certification information. The Emissions Durability Period describes the n

Mix stabilizer with fuel in fuel tank or storage container. Run engine for a short time to circulate stabilizer through carburetor. Engine and fuel can be stored up to 24 months. Note: If stabilizer is not used or if engine is operating on gasoline containing alcohol, e.g. gasohol, remove all fuel from tank and run engine until it stops from lack of fuel. Storage Procedures for Gas/LPG/NG engines. Fig. 2 Fig. 7 1. Change oil. See Oil service. 2. Remove spark plug and pour about 15 ml (1/2 oz.) o