WIRING DIAGRAM INSTALLATION This wall switch can be used for either single pole or multiswitch installation. A multiswitch installation with an electronic wall switch differs from conventional installation. Read wiring instructions carefully. Use guidelines applicable to your installation. Apply the following steps for all installations. Note: The black wall switch wires have no polarity. You can use any of them. 1. Interrupt power at circuit breaker to avoid electric shock. 2. Take out and disc

• Installation • Cut power at the circuit breaker to avoid electric shock. • Remove the existing switch. (For a 3-way installation, identify and label the wire that is connected to the “common” screw.) • Install the new switch (refer to the appropriate section below). • Apply power at the circuit breaker. NOTE A: The white wire is not the neutral wire but the wire going to the load. SINGLE-POLE INSTALLATION 120 VAC Neutral Line See NOTE A 120 VAC Line Neutral Connect wires "2" and "C" of TI034-3

If you have entered your city’s parameters (see section 7), the parameters P1 ON and P2 OFF show the sunset time and sunrise time for this time of the year. If the timer is used for lighting, when placed in AUTO mode, it will turn the light ON at sunset and will turn it Off at sunrise. For example: P1 ON : 20:38 (sunset) P1 OFF : --:-- (blank) P2 ON : --:-- (blank) P2 OFF : 6:10 (sunrise) • Press the HOUR and MIN buttons to set the time. Example: If you want your lights to turn On at sunset and