Оценок - , средний балл: ( )

Инструкция по эксплуатации Hans Grohe, модель PEKOE EXTENDER M968582

Производитель: Hans Grohe
Размер: 215.94 kb
Название файла: Install_2327.pdf

Язык инструкции:

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Work your way around LOCKNUT (7), tightening the screws slightly each time until all are snug to ensure even pressure. 1 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. Faucet supplies are 27-1/2" long from faucet base. Note: If additional supply length is required, installer must purchase additional parts separately. Important: If SUPPLY HOSES (1, 2) are too long, loop as illustrated to avoid kinking. TEST INSTALLED FAUCET Move HANDLE (1) into "off" position. Unthread SPRAY END (2) from SPOUT (3). Turn on water supplies and check connections for leaks.^ Operate HANDLE (1) on and off, hot and cold to flush water lines thoroughly. Replace SPRAY END (2). Check all drain connections for leaks. ^ Move HANDLE (1) to "off" position. 2 HOT & COLD SUPPLIES 2 M968582 REV.1.1 4 SERVICE Clogged CARTRIDGE outlets or inlets may cause reduced flow. To clean, first turn off water supply then: ■ Loosen and remove LEVER HANDLE (1). Loosen HANDLE SCREW (2) with 2.5mm Hex Wrench and then pull HANDLE BASE (3) off. Unscrew ESCUTCHEON CAP (4). Unscrew the CARTRIDGE NUT (5) and remove METAL WASHER (8). Remove CARTRIDGE (6). Clean inlets of CARTRIDGE (6) and MANIFOLD (7). Reassemble CARTRIDGE (6). Replace CARTRIDGE NUT (5), CAP (4), METAL WASHER (8) and HANDlE assembly, check flow. I-2 3 SERVICE If SPOUT (1) leaks at swivelpoint the O-RINGS (2) need to be replaced. To remove SPOUT (1): ■ Turn faucet to off position. Loosen the SPOUT SET SCREW (3) with a 3mm Hex wrench. ■ Rotate the SPOUT (1) side to side while pulling upward to remove SPOUT (1) from faucet body. ■ Replace the defective parts and grease O-RINGS (2). Push SPOUT (1) back into position. Tighten SET SCREW (3). ■ Check that SPOUT (1) rotates freely and does not leak at the swivel point. 3mm HEX WRENCH CARE INSTRUCTIONS: DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH. DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE. M968582 REV.1.1 5 6...