Оценок - 4, средний балл: 4.3 ( )

Производитель: Dolmar Размер: 11.27 mb Название файла: Язык инструкции:

Фото и характеристики  Dolmar  MS-245.4 UE

Engine stops soon Engine speed does not increase Insufficient warm-up Perform warm-up operation Choke lever is set to “CLOSE” although engine is warmed up. Set to “OPEN” Clogged fuel filter Clean Contaminated or clogged air cleaner Clean Abnormal carburetor Make request for inspection and maintenance. Abnormal drive system Make request for inspection and maintenance. Cutter blade does not rotate Loosened cutter blade-tightening nut Tighten securely Twigs caught by cutter blade or dispersion- preventing cover. Remove foreign matter Abnormal drive system Make request for inspection and maintenance. Main unit vibrates abnormally Broken, bent or worn cutter blade Replace cutter blade Loosened cutter blade-tightening nut Tighten securely Shifted convex part of cutter blade and cutter blade support fitting. Attach securely Abnormal drive system Make request for inspection and maintenance. Cutter blade does not stop immediately High idling rotation Adjust Detached throttle wire Attach securely Abnormal drive system Make request for inspection and maintenance. Engine does not stop Detached connector Attach securely Abnormal electric system Make request for inspection and maintenance. Stop engine immediately Stop engine immediately Stop engine immediately Run engine at idling, and set choke lever to CLOSE When the engine does not start after warm-up operation: If there is no abnormality found for the check items, open the throttle by about 1/3 and start the engine. 24 EMISSION COMPLIANCE PERIOD EMISSION COMPLIANCE PERIOD AIR INDEX An Air Index Information hang tag was supplied to this engine in accordance with the emission regulations of the California Air Resources Board. The bar graph on the hang tag shows the emissions performance of this engine. The bar graph can be used to compare the emissions performance with other available engine. The lower the Air Index, the less pollution. The following durability description is to provide you with information relating to the emission durability period of the engine. Descriptive Term Applicable to Emissions Durability Period Moderate – 50 hours (0-65 cc) Intermediate – 125 hours (0-65 cc) Extended – 300 hours (0-65 cc) Notice: The Air Index Information hang tag must remain on the engine or on the equipment until it is sold to the ultimate purchaser. Remove the hang tag before operating the engine. 25 FEDERAL EMISSION COMPONENT DEFECT WARRANTY EMISSION COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applicable in all States, except the State of California DOLMAR GmbH North American Division, (herein “Dolmar”) warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein “engine”) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fall to conform with EPA regulations during its warranty period. For the components listed under PARTS COVERED, the dealer or service center authorized by Dolmar will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U.S. EPA regulations. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. 1) Fuel Metering System 3) Ignition System (i) Carburetor and internal parts (i) Spark plug (ii) Fuel filter, if applicable (ii) Flywheel Magneto (iii) Throttle stopper, if applicable (iii) Ignition Coil (iv) Choke System, if applicable 2) Air Induction System 4) Miscellaneous Items Used in Above Systems (i) Air cleaner plate (i) Fuel hoses, clamps and sealing gaskets (ii) Air cleaner case (iii) Air cleaner element 2 OBTAINING WARRANTY SERVICE OBTAINING WARRANTY SERVICE WHAT IS NOT COVERED * Conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by Dolmar during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services. * The replacement parts used for required maintenance services. * Consequential damages such as loss of time, inconvenience, loss of use of the engine of equipment, etc. * Diagnosis and inspection charges that do not result in warranty-eligible service being performed. * Any non-authorized replacement part, or malfunction of authorized parts due to use of non-authorized parts. OWNER'S WARRANTY RESPONSIBILITIES As the engine owner, you are responsible for the performance of the required maintenance listed in ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: