Оценок - 5, средний балл: 3.6
(
)
)
|
Фрагмент инструкции
Y Use a hooked wire to extract the fuel filter from inside the fuel tank. Inspect the fuel filter element. If it shows signs of contamination, replace with a genuine Shindaiwa replacement fuel filter element. CAUTION! Make sure you do not pierce the fuel line with the end of the hooked wire. The line is delicate and can be damaged easily. Before reinstalling the new filter element, inspect the condition of all the fuel system components (fuel pick-up line, fuel return line, tank vent line, tank vent, fuel cap and fuel tank). If damage, splitting or deterioration is noted, the unit should be removed from service until it can be inspected or repaired by a Shindaiwatrained service technician. 139/150-Hour Maintenance ................................................................................ Hooked wire Maintenance after first 139-hours, then every 150-hours thereafter. Y Combustion chamber should be decarbonized, and the valve clearance should be adjusted. It is highly recommended that this is done by a Shindaiwa-trained service technician. Valve Adjustment 1. Remove cylinder cover, rocker arm cover, and spark plug. Rotate the crankshaft while observing the piston through the spark plug opening. When the piston is at the top of the compression stroke (TDC), the valves can be adjusted. CAUTION! Y Performing a valve adjustment incorrectly may cause hard starting and/or can damage the engine. Y If you are unfamiliar with this engine or uncomfortable with this procedure, consult with an authorized Shindaiwa servicing dealer. Y Replace the spark plug annually: Use only the type recommended in the ”Specifications” section or an equivalent resistor type spark plug of the correct heat range. Set spark plug electrode gap to 0.6 -0.7 mm. 2. Loosen adjuster locknut so that the 2.5 mm Allen socket head adjustment screw can turn freely. 3. Insert 0.10 mm feeler gauge between valve stem tip and rocker arm. 4. Turn adjustment screw (clockwise = tighter, counter-clockwise = looser) until feeler gauge is almost snug. Back off just enough to allow gauge to slip out with limited resistance. 5. While holding the adjustment screw in place with the Allen driver, tighten the locknut with a wrench. Y The valve clearance should be adjusted annually or every 135 hours. It is highly recommended that this is done by a Shindaiwa-trained service technician. 6. Turn engine over several times, and returnthe to TDC-compression. Recheck with proper feeler gauge to make sure clearance adjustment did not change as a result of tightening the locknut. Readjust as necessary. 7. Replace rocker arm cover gasket to assure proper sealing and install cover. IMPORTANT! If a new gasket is not available and/or the old gasket is not damaged, the old gasket may be reused. Never use cracked or damaged gaskets! Maintenance (continued) ........................................................................H If the engine becomes sluggish and lo...
Эта инструкция также подходит к моделям:Садовые инструменты - 89304 (1.76 mb)
Садовые инструменты - 89304 (1.76 mb)
Садовые инструменты - 89304 (1.76 mb)
Садовые инструменты - 89304 (1.76 mb)