Do not locate the grill in a building, garage or other enclosed area. • Ensure that fresh air ventilation is adequate. • Consider exposure to wind and proximity to traffic paths. • The minimum clearances to combustibles must be maintained at all times. • Do not install a grill below overhead unprotected combustible construction. • The installation must conform to local codes or in the absence of local codes, with the national fuel gas code, ANSI Z223 latest edition. Note: Reference pub. n

233 lbs. Length/Width/Height............................................................................................................................. 33 x 20 x 45 in. Foot Print (Length/Width).......................................................................................................................28 x 19-1/2 in. Shipping Dimensions: Type............................................................................................................................................

MODEL G1037Z 13" PLANER/MOULDER Product Dimensions: Weight..............................................................................................................................................................217 lbs. Length/Width/Height.................................................................................................................23-1/2 x 23 x 44-1/2 in. Foot Print (Length/Width)........................................................................................

paGc 1 3 ivioaei gooouz Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased. 1 3 Main Specifications: Operation Info Max. Cut Width.......................................................................... .................................................................20 in. Max. Cut Height......................................................................... ...................................................................

1600 lbs. Length/Width/Height.......................................................................................................................42-3/8 x 36 x 52 in. Foot Print (Length/Width)....................................................................................................................... 40-1/2 x 30 in. Shipping Dimensions: Type.............................................................................................................................................

Make sure that the knife is at the lowest point of its cutting arc. 4. Note the reading on the dial indicator face. 5. Remove the dial indicator and place it in the same position at the opposite end of the knife. Read the dial indicator again. If the reading is not equal to the first one, adjust one side of the planer bed until the readings are the same at both ends of the knife. Adjusting Bed Rollers 1. Rotate the dial indicator to the “Down-reading” position (see Figure 2). 2. Place the d

With proper care, the Mini Planer Pal® should provide you with years of reliable knife setting service. Do not try to use these jigs on larger diameter cutterheads since the preset knife height and curvature requirements will not be met. Planer Pal® offers larger, adjustable knife setting jigs for use on larger diameter cutterheads. CAUTION: The zinc coated neo-dymium magnets used in the Mini Planer Pals® are extremely strong, but they are very brittle. To avoid chipping the magnets, rock them

No. No. Used Description No. No. Used Description 1 911001-2 2 P.H. Screw M3x6 (With Washer) 51 251246-3 4 (+) P.H. Screw M4x5 2 * 2 P.H. Screw M4x14 52 342430-2 2 Adjust Plate 3 911228-4 2 P.H. Screw M5x18 (With Washer) 53 911226-8 2 P.H. Screw M5x18 (With Washer) 4 931106-2 2 Rivet 0-5 54 323001-4 1 Drum Rear Shaft 5 * 1 Switch 55 253139-0 1 Flat Washer 8 6 * * P.H. Screw M4x6 (With Washer) 56 211032-4 1 Ball Bearing 608ZZ (Old 210011-9) 7 682502-4 1 Cord Guard 8-85 57 961004-6 1 Retaining Rin