Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Besides the data sheet and parts in this insert, the content in the Model W1742 owner's manual is the same for both machines. Before operating your new machine, you MUST read and understand this insert and the entire Model W1742 manual to reduce the risk of injury from improper use or setup. If you have any further questions about this manual insert or the differences between the Model W1742S and the Model W1742, contact our Technical Support at (360) 734-3482 or email tech-support@shopfox.biz. COPYRIGHT © MAY, 2008 BY WOODSTOCK INTERNATIONAL, INC. REVISED SEPTEMBER, 2010 (TR) WARNING: NO PORTION OF THIS PUBLICATION MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT ^#10741TR_THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC._Printed in China j W1742S 15" Planer with Spiral Cutterhead MACH|NE /f SPECIFICATIONS v Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: , MODELW1742S 15" PLANER with SPIRAL CUTTERHEAD Motor Type..........................................................................................TEFC Capacitor Start Induction Horsepower.................................................................................................................3 HP Voltage......................................................................................................................220V Prewired.....................................................................................................................220V Phase....................................................................................................................... Single Amps.......................................................................................................................... 15A Speed.................................................................................................................. 3450 RPM Cycle........................................................................................................................60 Hz Number Of Speeds.............................................................................................................1 Power Transfer............................................................................................Triple V-Belt Drive Bearings...............................................................................................Sealed and Lubricated Main Specifications Operation Information Maximum Cutting Width..............................................................................................15" Maximum Cutting Height..............................................................................................8' Minimum Stock Length................................................................................................6' Minimum Stock Thickness.........................................................................................3/16' Maximum Stock Thickness............................................................................................8" Number of Cuts Per Inch........................................................................................104/56 Number of Cuts Per Minute (Effective)........................................................................20,000 Planing Feed Rate............................................................................................16/30 FPM Maximum Cutting Depth (Planing Full Width).................................................................3/32" Maximum Cutting Depth (Planing 6" Wide Board)...............................................................1/8" Cutterhead Information Cutterhead Type............................................Spiral with German-Made Indexable Carbide Inserts Cutterhead Diameter..................................................................................................3" Cutterhead Speed.............................................................................................5000 RPM Number of Cutter Spirals..............................................................................................4 Number of Indexable Inserts.........................................................................................74 Cutter Insert Type........................................................Indexable Carbide with 4 Cutting Edges Cutter Dimensions...................................................................................... 14 x 14 x 2 MM Table Information Table Size Including Wings......................................................................42"L x 15"W x IWT Table Movement........................................................................................................8" Floor to Table Height............................................................................................27"-35" Number of Bed Rollers.................................................................................................2 Overall Dimensions ...