ADDITIONAL EQUIPMENT (not included) 1) Three fresh 1.5V AA batteries (optional for alarm clock) 2) Two fresh 1.5V AA batteries (for remote transmitter) ABOUT WWVB (Radio Controlled Time) The NIST (National Institute of Standards and Technology—Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time signal continuously throughout the United States at 60 kHz. The signal can be received up to 2, 000 miles away through the internal antenna in

Instruction manual 3. Warranty card ABOUT RADIO-CONTROLLED TIME - WWVB The NIST (National Institute of Standards and Technology—Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time and date signal continuously throughout the United States at 60 kHz. The signal can be received up to 2,000 miles away through the internal antenna in the alarm clock. Due to the nature of the Earth’s Ionosphere, reception is very limited during daylight hou

To install and replace the batteries, please follow the steps below: 1. Pull down on the tab at the top of the battery cover and lift up to remove the cover. 2. Insert batteries observing the correct polarity (see marking inside battery compartment) . 3. Replace compartment cover. DO NOT SET THE CLOCK. SETTING UP: Alkaline batteries are recommended for use. Avoid using rechargeable batteries. 1. Place batteries in the atomic clock. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES. 2. After 15 minutes the

To install and replace the batteries, please follow the steps below: 1. Insert finger or other solid object in the space at the bottom center of the battery compartment and lift up to remove the cover. 2. Insert batteries observing the correct polarity (see marking inside battery compartment). 3. Replace compartment cover. DO NOT SET THE CLOCK. TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please

III) DST (DAYLIGHT SAVING TIME) SETTING Note: The DST default is “On”, meaning that the WWVB will automatically change the time according to Daylight Saving Time in the spring and fall. For areas that do not recognize DST changes (Arizona and parts of Indiana) turn the DST “OFF”. 1) Hold down the “SET” button for 2 seconds (the selected time zone will flash), press the “SET” button once more until “On” flashes in the time LCD and “DST” flashes where the Weekday normally appears. 2) Press and rel

1 Projection clock with radio, 1 Operating manual The batteries and a 3V-mains adaptor (accessories), required for operation, are not included in the supply. Operating Elements q Projection lens w Telescopic antenna e Button Snooze r Projection, Display illumination t Display y Frequency scale u Button Alarm i Button Hour o Button Time a Button Min (Minute) s Loudspeakers d Projection focus f Tuning wheel g Volume controller VOLUME / BUZZ h External 3V Direct current connection for 4.0 mm x 1.7

CV_KH2201_02_AR909_LB3 12.11.2007 11:08 Uhr Seite 1 KOMPERNASS GMBH · BURGSTRASSE 21 D-44867 BOCHUM ID-Nr.: KH2201_02-10/07-V2 PROJECTION CLOCK KH 2201 KH 2202 3 PROJECTION CLOCK Operating instructions PROJEKTIONSUR Betjeningsvejledning PROJEKSJONSKLOKKE Bruksanvisning NIEIU-.NIAIEEAO Iaca.ao .n.oco PROJEKTIONSUHR Bedienungsanleitung h h CV_KH2201_02_AR909_LB3 12.11.2007 11:09 Uhr Seite 5 KH 2201 KH 2202 wu qwe r e t y r u i o a a 2) j d f ; k q g h g ; s j d s kl o ty f IB_KH2201_02_AR909_UK_3.

After unpacking the device, immediately check to determine that all listed items are present and that the device is in a faultless condition. Remove all packagng materials and the protective foil from the display. Operating Elements q Projection lens w Telescopic antenna e Switch ALARM ON/OFF/AUTO r Button SNOOZE t Waveband selector FM/AM y Button PROJECTION LIGHT, Display illumination u Switch PROJECTION ON/OFF i Display o Sound volume regulator OFF/BUZZ/VOLUME a Connection for 3V power adapter

Pass this manual on to whoever might acquire the device at a future date. - 1 PROJECTION ALARM CLOCK KH2198/99 Safety information To avoid potentially fatal injury through electric shock: • Only use the device in dry rooms. • Never allow fluids or objects to penetrate into the device. • Do not place objects containing fluids, e.g. flower vases, on the device. To avoid burn and other injuries: • Place the device in an open and well-ventilated area so that heat pockets cannot be created within i

- 3 IB_KH2201_02_AR909_UK_4.qxd 12.11.2007 13:10 Uhr Seite 4 PROJECTION CLOCK Safety instructions To avoid fatal injury through electric shock: • Use the clock in dry environments only. • Make sure that fluids or any other objects do not get inside the device. • Do not place objects containing fluids, e.g. flower vases, on the appliance. To avoid burn and other injuries: • Place the appliance in an open and well-ventilated area so that heat pockets cannot be created within it. Never cover the