Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
The watch will start counting from 00'00"00 if the watch is cleared. Otherwise, it will pick up from where it last left off. The watch will count up to limits before starting from zero again. 3. To stop counting, press the STOP/RESET button once. Press the START/SPLIT again to resume from where it left off. To clear the chronograph, press the STOP/RESET button to stop counting and hold the same button to clear. The chronograph is equipped with a split function for you to keep track of individual lap time. To use the function, 1. While the chronograph is running, press the START/SPLIT button once whenever you want to register a lap. The lap number and lap time will be shown. 2. Repeat the last step until you have registered all the laps. You can register up to 99 laps and the lap number will be automatically generated. Only 45 laps will be stored and will be shown in recall mode. 3. Press and hold the STOP/RESET button to clear when chronograph is stopped. To retain the recorded laps and total time in memory, press and hold the SET button. Then the remaining lap space in memory will be displayed. TO SET THE DISPLAY FORMAT 1. Press SET/RECALL button to enter the display format setting when no lap records are in memory, or press the MODE button when viewing the lap records in the RECALL mode. 2. Select LAP/SPL to display the lap time on the top and split time at the bottom. Or select SPL/LAP to display the split time on the top and lap time at the bottom. TO CHECK LAP RECORDS You can check the lap records in RECALL mode. The mode will only be active when there are records in memory. To use the function, select Chronograph mode using the MODE button. While the chronograph is running or stopped, Press the SET button to enter Recall mode to view the current lap time. TO CLEAR LAP MEMORY CLEAR ALL In Chronograph mode, when the chronograph is not running press and hold the STOP/RESET button to clear all records in memory. TIMER MODE No. of Interval TO SET THE COUNTDOWN TIMER(S) 1. Select TIMER mode using the MODE button. The last operating status of the timers will be displayed. 2. Press the SET button. The parameters will blink and are set by pressing MODE in the order of: • Timer type Select timer interval 1 or 2 • Hours Enter the desired hours • Minutes Enter the desired minutes • Seconds Enter the desired seconds • Stop or repeat option Select STOP AT END to stop after each countdown or REPEAT AT END to reload and repeat the countdown after reaching zero To start a countdown, press the START/SPLIT button. To stop, press the STOP/RESET button. To continue the countdown, press the START/SPLIT button again. You can clear a countdown to zero by pressing and holding the STOP/RESET button after resetting the countdown or finishing the setting. When a countdown reaches zero, the back light will flash and beeps will be emitted. Press any button to turn off beeping when timer goes off. If the REPEAT AT END option is chose...
Эта инструкция также подходит к моделям:Регистраторы времени - FS80932 (1.04 mb)
Регистраторы времени - FS80933 (1.04 mb)
Регистраторы времени - FS80935 (1.04 mb)