indicator will flicker. 2. Press the PLAY/PAUSE. button again to continue play. REPEATING PLA. . Press the REPEAT ONE.ALL butto. once during playback, the REPEAT ON. indicator will light up. . Press the REPEAT ONE.ALL button . second time to repeat all tracks, th. REPEAT ALL indicator will flicker. . Press the REPEAT ONE.ALL button unti. the REPEAT indicator is turned off. NOTE: The display will be returned to clock about 10 seconds. WAKE UP TO ALARM (RADIO, BUZZER OR CD) The radio, buzzer or CD

Although this transmitter can be programmed into any of the Audiovox remote start and/or alarm, remote start systems, it will offer limited use and should be used for the remote start upgrade only. To program this transmitter into your remote start upgrade unit: 1) Turn the ignition to the on position. 2) Press and release the programming switch 3 times. 3) Press and hold, for 3 seconds, the button of the transmitter you wish to add until the parking light flashes, indicating the transmitter

Lock and arm/unlock and disarm. May be programmed to unlock driver's door or all doors. Also will initiate and terminate *Panic. Pulsed or switched output to control Remote Trunk Release or optional device connected to channel 3. When pressed and release two times, will provide pulsed output or activate the Remote Start option when installed. When so equipped, this button can be used to operate an optional device connected to channel 4. When so equipped, this button can be used to operate an opt

5010000657 Metal Poles, long (2) Part No. 5010000656 Metal Pole Tip in Grommet Metal Pole Tip Metal Pole Tip in Grommet V Sun Shade Assembly 1. Assemble the shock-corded short and long Metal Poles. (Fig. 1) 2. Insert narrow metal tip on long Metal Pole into metal grommet located on the web strap long end of the sun shade. (Fig. 2) 3. Lift pole to upright position; then extend out the guylines tied onto the web strap. (Fig. 2) 4. Slip loop on each guyline over plastic stake and drive in

SELECT BAND 1. Press “POWER ON/OFF” knob to turn on radio. 2. Press “BAND” knob to repeatly select FM or AM, the band changed shown in display. 3. Press “ H...TIME SET...M / TUNING” knob to select the desired station. PRESET CHANNEL 1. Press “MEMORY” knob until “MEMORY” flashes on screen. 2. Press “PRESET +” knob to increase channel, press “PRESET -” knob to decrease channel. 3. Press “MEMORY” knob to store. FM: Extend the FM wire antenna fully. AM: Turn the unit to find the position which gives

3 Turn the Control Wheel to highlight Antenna Aiming and press Select. If you’re receiving good Satellite and Terrestrial signal strength, you’re done If not, try some of the suggestions which follow Other Indoor/Outdoor Home Antenna Installation Suggestions If you find you are getting a signal, but it’s inconsistent, try moving the Indoor/ Outdoor Home Antenna closer to a window, ideally one that is facing due south S Not sure which way is south? Think about where the sun rises (in the east) an

Activate your XM subscription online at or by phone 1 800 XM RADIO (1-800-967-2346 ) 3. Listen to XM* 4. Identify and easily access your favorite channels by using the f ffa aav vvo oor rri iit tte ees ssbutton *Hardware and required monthly subscription sold separately. Installation cost and other fees and taxes, including a one-time activation fee, may apply. Subscription fee is consumer only. XM products, programming, services, and fees are subject to change, at any time, without notice. Chan

We are thrilled you have chosen XM to be your satellite radio service provider. We will do everything we can to make your listening experience second to none! The XM Connect and Play is a fully integrated XM receiver and the only thing you need to receive XM Satellite Radio through your XM Ready® home or portable audio system. Getting XM couldn’t be simpler*. The following instructions will guide you through the basics of setup, signal acquisition, and XM service activation. For detailed instruc

RealAudio is a trademark or a registered trademark of RealNetworks, Inc. General controls Turning on or off Press ON/STANDBY to turn the radio on or off (standby mode). Volume control Rotate the VOL. knob to adjust the volume. Source selection Press SOURCE repeatedly to select among the following audio content sources: • Slacker Radio, Internet Radio, USB Input, Internal Memory, FM Tuner, AM Tuner Weather forecast Press WEATHER to check current and 3-day forecast. Refer to page 26 for more infor

Although this transmitter can be programmed into any of the Audiovox remote start and or alarm, remote start systems, it will offer limited use and should be used for the remote start upgrade only. To program this transmitter into your remote start upgrade unit: 1) Turn the ignition to the on position 2) Press and release the programming switch 3 times 3) Press and hold, for 3 seconds, the button of the transmitter you wish to add until the parking light flashes indicating the transmitter ha