Оценок - 3, средний балл: 4.3 ( )

Производитель: Allstar Products Group Размер: 468.12 kb Название файла: Язык инструкции:

Defective parts will be repaired or replaced with new or factory rebuilt parts at Allstar’s sole option. This limited warranty does not cover non-defect damage, damage caused by unreasonable use, damage caused by improper installation or care, vandalism or lightning, fire or excessive heat, flood or other acts of God (including, but not limited to misuse, abuse or alterations, failure to provide reasonable and necessary maintenance) , labor charges for dismantling or reinstalling a repaired or replaced unit, or replacement batteries. These warranties are in lieu of all other warranties, either expressed or implied. All implied warranties of merchantability and/ or fitness for a particular purpose are hereby disclaimed and excluded. Under no circumstances shall Allstar be liable for consequential, incidental or special damages arising in connection with the use or inability to use this product. In no event shall Allstar’s liability for breach of warranty, breach of contract, negligence or strict liability exceed the cost of the product covered hereby. No person is authorized to assume for Allstar any other liability in connection with the sale of this product. This warranty gives you specific legal rights. Warranty effective after July 24, 2002. WARNING Unexpected door operations can cause personal injury or property damage. This device complies with Part 15 of the FCC Rules and with RSS- 210 of Industry Canada. Operation is subject to the following two conditions: ( 1) This device may not cause harmful interference, and ( 2) this device must accept any interference received, including interference that may cause undesired operation. Copyright © 2002 c. p.Allstar Corporation PART NUMBER 111243 REV F Allstar Radio Controls are compatible with HomeLink ® . Homelink ® is a registered trade mark of Johnson Controls, Inc. NOTE: The table has a row for each one of the three buttons since it is possible to set a unique code for each button. Write the code that you matched from your transmitter or receiver in the grids below. 1 2 3 4 5 6 7 8 9 + / On BUTTON Zero BUTTON - / Off BUTTON - PUT THE TRANSMITTER IN PROGRAM MODE 1. First, press and hold the + 1a. First, press and hold the - button. The Red LED will turn on. Next, button. The Red LED will turn on. Next, while continuing to hold the + button, while continuing to hold the - button, press and hold the - button. Continue press and hold the + button. Continue to hold both buttons until the LED starts to to hold both buttons until the LED starts to blink ( approximately 5 seconds) . Release blink ( approximately 5 seconds) . Release both buttons while the LED is blinking. both buttons while the LED is blinking. The LED will blink two times and then The LED will blink two times and then remain on to confirm you are in remain on to confirm you are in programming mode. Go to Step 2 programming mode. Go to Step 2 *If the LED goes out, *If the LED goes out, start over. start over. - SELECT THE BUTTON YOU WIS...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: