Оценок - 4, средний балл: 4.3 ( )

Производитель: Allstar Products Group Размер: 468.12 kb Название файла: Язык инструкции:

Next, button. The Red LED will turn on. Next, while continuing to hold the + button, while continuing to hold the - button, press and hold the - button. Continue press and hold the + button. Continue to hold both buttons until the LED starts to to hold both buttons until the LED starts to blink ( approximately 5 seconds) . Release blink ( approximately 5 seconds) . Release both buttons while the LED is blinking. both buttons while the LED is blinking. The LED will blink two times and then The LED will blink two times and then remain on to confirm you are in remain on to confirm you are in programming mode. Go to Step 2 programming mode. Go to Step 2 *If the LED goes out, *If the LED goes out, start over. start over. - SELECT THE BUTTON YOU WISH TO USE 2. While the LED is on, press the button you wish to use. (If your block has 8 switches press the + button, if not, press any button you’d like to use) . The LED will blink off once and then remain on. Go to Step 3. .. - ENTER YOUR 9 DIGIT CODE 3. Enter the 9- digit code from the table pressing the buttons that correspond with the grid above. (If your block has 8 switches use the + button in the 9th position) Go to Step 4. .. 4. After the 9- digit code is entered, the LED will blink twice to confirm a valid code and remain off. 5. Repeat the procedure for the remaining buttons. INSTRUCTIONS FOR USE WITH AN ALLSTAR SMART RECEIVER When using the Allstar Classic with a Smart Receiver there is no need to match a switch setting. Simply make up your own unique code, enter it in the grid on page 2 and follow the instructions starting with Step 1. When the transmitter is programmed, follow the instructions for teaching the receiver the transmitter code. Note: If you want to program all the buttons you can Express Code them by selecting the + button in Step 2 and ending the 9 position code in Step 3 with a + . This will code all three buttons in one programming step. IMPORTANT The SAME CODE must be set on both the transmitter and receiver. The controls will not function if the codes are mismatched. Keep transmitters and remote controls out of the reach of children. Do not let children play with or use the transmitter or remote controls. Unexpected door operations can cause personal injury or property damage. Do not place transmitter where the buttons can be accidentally or unintentionally activated. WARNING Installing the Transmitter Battery Replacement The transmitter is The MVP Quik-Code transmitter is provided with two supplied with a metal factory installed 3- volt batteries which should be clip which may be used replaced after two years of normal use. The transmitter to attach the unit to a code is retained in permanent memory and will not be sun visor. If the clip is lost during battery replacement. To replace the used, slide it into the batteries, remove the back of the case with a small recess provided on the screwdriver. Carefully slip the batteries out of the back of the transmitter holders and rep...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: