Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Buzzer Radio Playback Indicator Tima/Alarm/Radio Display in-nOr •rlUUÜS TIUUUUUUUUULIUUU— -KHz/MHz Indicator IMPORTANT INFORMATION REQUIRED BYTHE FCC This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interference received, including interference that may cause undesirable operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions, may cause harmful interference to radio elevation reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of following measures:. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help. Setting the Clock 1 .To set the time, Locate the “Time” button, press and hold the “Time” button down, and press “hour” or “min” button to adjust hour or minute, Time is displayed in the 12-hour format, An icon to the left of the display indicated PM. Setting Alarm 1 .To set the Alarm, press and hold "al-time” button, and press "hour” or “min” button to adjust hour or minute, Time is displayed in the 12-hour format. An icon to the left of the display indicated PM. 2.Switch “wake to---” button and select the option for sound source: iPod, radio or buzzer, Notes on setting alarm: 1 .The user only can set the clock or alarm in power-off status. 2.To make the alarm setting effective, Before setting alarm time, please note to make” AL” icon in the LCD displayer is in light -off status, after setting the new alarm time, then press “al- on/off “button to make alarm on 3. Take notice of the adjusted volume level and make sure it is set at an appropriate level for waking up. 4. When snooze function in Radio/Buzzer mode is activated, setting new Alarm will be not effective. Listening to Your Songs on iPod 1 .To Listening to music, switch the button to iPod playback and "iPod” icon will be light on the LCD displayer. 2.Insert your iPod into the universal dock, Press the button on iPod to play the music. Charging Your iPod Your iPod will always be charging until reaching the full charge mode. Listening to Your Radio Station 1.To turn the radio on, swith the button to radio playback and “Radio” icon will be light on the LCD displayer. 2.To select AM or FM, switch the "AM/FM” button 3.To tune in a desired station, rotate the “TUNING" knob. Listening to Other Audio Device Insert one end of 3.5mm audio cable (not included) into the headphone or line-out jack on the audio device, then insert another end of audio cable into the AUX jack, located on the rear of unit. Using the Alarm Function 1 .To preview the alarm time, press the "al-time" button once in power-off status. 2.To activate or deactivate the alarm, press the "al-on/off1 button, the “AL” icon will be light on or off on the LCD displayer 3.To snooze, press "snooze” button, following the sounding of the alarm. The alarm will then shut off and will sound again in 5 minute. You will have the opportunity to repeat this cycle 12 times during one hour allotted alarm cycle. 4.To turn the alarm off, press the “power” or "al-on/off” button(only in Radio/Buzzer mode), If all settings remain the same, the alarm will turn on the following day at the same time. Notes on Alarm Function 1 .Snooze function is no effective in iPod mode. 2.When alarm is on in iPod mode, to turn off alarm, press “power” button, “al-on/off” button is no use. 3.Setyour iPod to the repeat mode if you’ re selected wake to iPod, and your iPod has less then one hourof songs. 4.In order to wake to iPod or radio, the unit must be powered off. If it is in the iPod/radio play mode, No alarm will sound. Set up the unit to work with the AC adapter Attach AC adaptor cable to jack AC 7V IN jack on the rear of unit, and plug the other end into a wall socket. Specifications: RECEIVER FREQUENCY: AM 530-1710 KHz FM 87.5-108 MHz RECEIVER SENSITIVITY: AM s£ 74 dBm FM =S 26 dB RECEIVER S/N: AM S*25dB FM & 40 dB POWER OUT PUT: 2*0 .18W ( 1 KHz ) AUX IMPUT SENSITIVITY: 380mV (1KHz OdB) POWER IMPUT: AC 7V ¡Mode SERIES SYLVANÊA MANUEL D'UTILISATION RADIO-REVEIL SIP198 Commutateur réglage d'heure Alarme On/Off La touche pour mettre l’appareil en sommeil Alarme activée en mode Alimentation CA 7 V Affichage de Heure/Alarme/Radio Affichage de mode d’alarme en iPod, Rad...