Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
After selecting a cleaning mode, press the ((g)) button to start cleaning. 9. Timer/Daily - Press to set a scheduled or daily cleaning. 10. Recharging - When this button is pressed, the Recharging icon is turned on and the cleaning robot will return to the charger station to charge its battery. Assembling the cleaner _19 02 ASSEMBLING THE CLEANER Operating the cleaner INSTALLING THE ROBOTIC VACUUM CLEANER INSTALATION ORDER_ 1. Turning the Power Switch on or off To use the robotic vacuum cleaner, you must turn on the Power Switch at the bottom of the main unit. 2. Installing the Charger To charge the robotic vacuum cleaner, you must first install the charger. Since the battery is discharged when the product is purchased, you must fully charge the battery before use. 3. Charging the Battery You should charge the battery completely before using the robotic vacuum cleaner. 4. Setting the Time You should set the time to use the scheduled and daily cleaning options. 5. Installing the VIRTUAL GUARD You can confine the robotic vacuum cleaner to a particular section by using Fence (virtual wall) mode or clean several sections one by one using Guard (virtual door) mode. 6. Attaching a mop Attach the mop to the bottom of the cleaning robot. TURNING THE POWER SWITCH ON OR OFF To use the robotic vacuum cleaner, you must turn the Power Switch on. If you turn the Power Switch off, all settings will be reset. 1. Turn over the main unit and turn the Power Switch on. - I f the icons are not turned on, it indicates that the battery charge is depleted. In this case, dock the robotic vacuum cleaner to the charger station after turning the Power Switch on. - The configured time may be different from the current time. If the configure time is incorrect, set the time to the current time. ^ If no key is pressed for approximately 5 minutes after turning the power on, the power is automatically cut to prevent the battery discharging. To turn the power on again, press and hold the power (Run/Stop) button on the main body or on the remote control for a short while. A If the Power Switch is turned off, the robotic vacuum cleaner will not be charged CAUTION even if it is docked with the charger station. 20_ Operating the cleaner inn the cleaner INSTALLING THE ROBOTIC VACUUM CLEANER INSTALLING THE CHARGER 1. Install the charger on a flat surface. 2. There should be no obstacles 0.5 m to the left and right and within 1 m of the front. 3. Install the charger in a location where it can be easily accessed by the robotic vacuum cleaner. 4. Arrange the power cord along the wall. 5. When the floor is made of wood, install the charger in the same direction as the grain of the wood. Always keep the power cord of the charger NOTE plugged into the power outlet. - If no power is supplied to the charger, the robotic vacuum will not be able to find the charger and will not be able to charge automatically. - If the robotic vacuum cleaner is separated from the charger, the battery is automatically discharged. Operating the cleaner _21 03 OPERATING THE CLEANER Operating the cleaner INSTALLING THE ROBOTIC VACUUM CLEANER CHARGING 1. After aligning the charge pins of the main unit with the charge pin of the charger station, press the main unit until you hear a “Recharging power” sound from the charger. - The Charging Lamp turns green. 2. Check the charge status of the robotic vacuum cleaner. - When charging starts, the battery level indicator and “ B ” will be displayed in sequence in the display panel. - When charging is complete, the battery level indicator and “FULL” will be displayed in the display panel. Charging Fully charged ■ When the battery level display flashes while cleaning, the robotic vacuum cleaner stops vacuuming and automatically charges itself at the charger.
Пылесосы - SR8896 (82.54 mb)