™ . & ^ % $ # @ ! 1 3 4 5 6 7 8 9 02 * ( ) . ™ . & ^ % $ # @ ! ENGLISH Contents 1. Introduction ......................................................................................................4 2. Installing the remote control ....................................................................4-8 Replacing the battery.......................................................................................................4-5 Testing the remote control ........................................

Do not forget to note your code. • If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list. 7 Instructions for use English SRU740_10_v2.qxd 26-04-2005 15:19 Pagina 7 Instructions for use English 3. Keys and functions The illustration on page 3 gives an overview of all keys and their functions. 1 y Standby . . . . . . . . switches TV, SAT, DVD,VCR or AMP on or off. 2 Indicator LEDs 3 -teletext on/off (disc menu) -text o

Example of TV: 1 Turn your TV on manually or use the original remote control. Tune to channel 1. 2 Press the SELECT key to select TV. Press the key until TV lights up in the selector window. If TV does not light up, check whether the batteries are properly inserted (see ‘Inserting the batteries’). 4 Instructions for use 3 Check whether all keys are working. For an over view of the keys and their functions see ‘3. Keys and functions’. – If the TV responds as it should to all of the key commands t

Для ТВ, видеомагнитофона и декодеpа спутникового телевидения пpедусмотpены pазные таблицы символов. 3 Нажмите кнопку SELECT для выбора телевизора. Держите эту кнопку, пока кнопка Standbyне загорится. 4 Нажмите и держите кнопки 1 и 3 одновременно в течение трёх секунд, пока кнопка STANDBY не мигнёт дважды, после чего она будет продолжать гореть. 5 После зтого введите код, записанный в шаге 2, с помощью кнопок с цифрами. – Кнопка STANDBY мигнёт дважды. Если эта кнопка мигает один раз в течение про

It is possible that you must enter another code for the device. 4. Extra possibilities Adjusting device selection (Mode selector) The SRU560 is default set for operating TV,VCR, CD, DVD, SAT (settop box, satellite or cable decoder) and AMP (amplifier).You can select the device you wish to operate with the SELECT key (mode selector). Each option allows operation of one device only. If desired, you can program the SELECT key (mode selector) to select a different kind of device. For example, if you

Remove the grate. This Remote Control Replacement Kit is to be used to replace the Reflections Electric Fireplace’s Remote Control. The kit components are shown below. (Kit Number H1454 And/Or H6977) REPLACEMENT INSTRUCTIONS Note: Depending on the type of control board in your fireplace, the number of steps and components may vary. Following are the types of control boards for identification: If you have Kit Number H1094, it will be necessary to replace the board and IR cables. In this case, com

Figure 6 Cut Wire Ties If Provided Locate The TV IR Cable Figure 7 Twist And Tape Figure 8 Pull To Replace Step 17. Pull the TV IR cable until the new cable is out. Unwrap the tape and discard the old cable (seeFigure 8). Step 18. Locate the Remote Control receiver through the rectangular slot and pull the cables out and cut the ends free, enough to wrap the end of the new receiver. Then fish them through the rectangular hole while pulling, to route through the frame cavity (seeFigure 9. ) Step

Introduction ......................................................................................................4 2. Installing the remote control ....................................................................4-8 Replacing the batter y.......................................................................................................4-5 Testing the remote control ...............................................................................................5 Setting the remote contro

3-4 2 Getting started ................................................................. 4-9 2.1 Inser ting the batteries ............................................................... 4 2.2 Testing the universal remote control ...........................4-5 2.3 Setting up the universal remote control ....................5-9 3 Using the universal remote control........................... 9-15 3.1 Buttons and functions.........................................................9-12 3.2 Controlling c

. . . . . . . . . . . . . запись ;. . . . . . . . . . . . . . . . . -жёлтая кнопка телетекста -пауза (VCR/DVD) ! / . . . . . . . . . . . . . . . выбоp одно- или двузначныx номеpов каналов @ 2 22 . . . . . . . . . . . . . . . выбирает предыдущую программу/канал. # - PROG + . . . . . . . . пеpеключение на пpедыдущий или следующий канал. $ OK. . . . . . . . . . . . . . . подтвеpждение выбоpа % BACK . . . . . . . . . . . . .возвращает на один уровень назад в меню или выключает меню. ^ TV/DVD/VCR. .