Оценок - 5, средний балл: 4
(
)
)
|
Фрагмент инструкции
For more than 50 years FURUNO Electric Company has enjoyed an enviable reputation for quality and reliability throughout the world. This dedication is furthered by our extensive global network of agents and dealers. Your equipment is designed and constructed to provide commercial grade performance and reliability, yet is affordable for pleasure craft owners. Please carefully read this manual and follow procedure for installation, operation maintenance. With proper care, your equipment should provide years of enjoyable and dependable Thank you for considering and IMPORTANT DFEATURES . Standard 4..6. flush mount design . Built-in DSC meets RTCM SC101 requirement . Rugged waterproof construction . NMEA Input/Output . Optional CONTROLLABLE MIC is connectable READ ALL INSTRUCTIONS carefully and completely SAVE THIS INSTRUCTION — This in- before using the struction manual the FM-3000. IN CASE OF EMERGENCY If your vessel requires assistance, contact other vessels and the Coast Guard by sending a distress call on Ch 16. USING CHANNEL 16 DISTRESS CALL PROCEDURE 1. “MAYDAY MAYDAY MAYDAY. ” 2. “THIS IS ...............” (name of vessel) 3. Your call sign or other indication of the vessel (AND 9digit DSC ID if you have one). 4. “LOCATED AT ...............” (your position) 5. The nature of the distress and assistance required. 6. Any other information which might facilitate the rescue. Or, transmit your distress call using digital selective Ch 70. USING DIGITAL SELECTIVE CALLING (Ch 70) DISTRESS CALL PROCEDURE 1. While lifting up the switch cover, push and hold [ [[ DISTRESS DISTRESSDISTRESS] ]] for 5 sec. until you hear 5 short change to one long beep. 2. Wait for an acknowledgment • Channel 16 is automatically 3. Push and hold [ [[ PTT PTTPTT] ]] , then transmit information NOTE A WARNING STICKER is supplied with the transceiver. To comply with FCC regulations, this sticker must be affixed in such a location as to be readily seen from the operating controls of the radio as in the diagram below. Make sure the chosen location is clean and dry before applying the sticker. (p. viii) EXAMPLE CLEAN THE TRANSCEIVER AND MICROPHONE THOROUGHLY WITH FRESH WATER after exposure to water including otherwise, the switches may RR SAFTY INSTRUCTION For the operator R RR CAUTION Do not open the equipment. Only qualified personal should work inside the equipment. Do not disassemble or modify the equipment. Fire, electrical shock or serious injury can result. Turn off the power immediately if waterleaks into the equipment or the equipment smoke or fire. Continued use of the equipment can cause shock. Any repair work must radio technician. Improper repair work R RR CAUTION BE CAREFUL! The transceiver and optional FM-3010 employ waterproof construction, which corresponds to JIS waterproof specification, Grade 7 (1 m/30 min.). However, once the transceiver or microphone has been dropped, waterproofing cannot be guaranteed due to the fact that the case may be cracked, or the waterproof seal damaged, etc. AVOID the use of chemical agents such as benzine or alcohol when cleaning, as they may damage the transceiver surfaces. Distances at which radiation levels of exist are given in the table. Distance to Distance to 100 W/m2 point 10 W/m2 point 0.12 m 0.39 m For the installer R RR WARNING ELECTRICAL SHOCK HAZARD Do not open the equipment unless totally familiar with electrical circuits and service manual. Only qualified personal should work inside the equipment. Be sure that the power supply is compatible with the voltage rating of the equipment. Connection of an incorrect power supply can cause equipment damage. The voltage rating of the equipment appears on the label above the power connector. Turn off the power at the switchboard beginning the installation. Fire or electrical shock can result DO NOT install the equipment where the vessel may be hindered injury. RR WARNING DO NOT cut the DC power cable between the DC plug and fuse holder. If an incorrect connection is made after cutting, the equipment may be damaged. R RR CAUTION Ground the equipment to prevent electrical shock and mutual interference. Observe the following compass to prevent interference compass: Standard Steerling compass compass Transceiver 0.95 m 0.65 m Table of Contents FOREWORD ............................................................. i IMPORTANT .............................................................. i IN CASE OF EMERGENCY ..................................... ii NOTE ........................................................................ ii SAFTY INSTRUCTION ............................................ iii Table of Contents ..................................................... v System Configulation .............................................. vii Standard supply & Options .................................... viii 1 Control ........................................................ 1 1.1 Front Panel ................................................... 1 1.2 ...