Specially manufactured metal duct, on the other hand, is quite expensive. Metal duct is also generally more difficult to cut and assemble. FLEXIBLE HOSE Flexible rubber hose, polyethylene, plastic flex- hose and other flexible ribbed hose is generally used for short runs, small shops and at rigid ductto- tool connections. There are many different types of flex hose on the market today. These are manufactured from materials such as polyethylene, PVC, cloth hose dipped in rubber and even metal, in

#JB11086 printEd in China ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

1 Hammer Head w/Coil Spring............................. 1 Die 7.8"-Shaft 1"-Radius...................................... 1 Die 7.8"-Shaft 2"-Radius...................................... 1 Die 7.8"-Shaft 3"-Radius...................................... 1 Hex Wrench 4mm.............................................. 1 Hex Wrench 5mm.............................................. 1 Figure 1. Model G0711 Planishing Hammer. MODEL G0711 PLANISHING HAMMER INSTRUCTION SHEET This machine can cause serious

There are many different types of flex hose on the market today. These are manufactured from materials such as polyethylene, PVC, cloth hose dipped in rubber and even metal, including steel and aluminum. There are also many kinds of pure plastic flexible hose, such as non-perforated drainage type hose and dryer vent hose. Drainage type hose, while being economical, does not quite have the flexibility required for dust collection. The inside of the duct is also deeply corrugated and can increase

figure 70. Metal reducers & Adapters. g6252—4" floor sweep g7341—5" floor sweep g7342—6" floor sweep great for cleaning up around the shop, these metal floor sweeps close tight when not in use. figure 71. industrial Floor sweep. -43 Model g0442/g0601 (Mfg since 3/12) section 7: maintenance always disconnect power to the machine before performing maintenance. failure to do this may result in serious personal injury. schedule For optimum performance from your machine, check the following items dur

G1028Z/G1029 Dust Collector -21 WIRE DIAGRAM 110 VOLT GREEN (GROUND) TO 110 VOLT POWER SUPPLY 220VOLT NOTE: THE WIRES FROM THE POWER SUPPLY, BESIDES THE GREEN GROUND WIRE, ARE INTERCHANGEABLE, THEREFORE COLORS ARE NOT SPECIFIED. 6A MOTOR WIRES BLACK YELLOW WHITE RED MOTOR WIRES BLACK YELLOW RED WHITE GREEN (GROUND) TO 220 VOLT POWER SUPPLY -22-G1028Z/G1029 Dust Collector Customer Service #: (570) 546-9663 • To Order Call: (800) 523-4777 • Fax #: (800) 438-5901 MACHINE DATA SHEET Customer Service

When the lid is closed, tabs in the lock bar engage the pockets on the drawers. When the lid is open, the tabs are raised clear of the pockets. Important: The drawer must be fully closed before the lid is shut. DO NOT slam the drawers when the lid is shut; they will not lock and damage to lock bar tabs or lock pockets may occur. Should this happen, remove the drawer and straighten out the deformed tab with a screwdriver. For the lock pockets, a pair of pliers should be used. See (1A) lock bar t

2. Hydraulic fluid low. 3. Hydraulic system damaged or fluid is leaking out. 1. Open screw two full turns. 2. Check fluid level, add fluid. 3. Repair/replace damaged parts. Ram works, but logs are hard to split. 1. Log unsuitable: twisted grain, high moisture content, heavily knotted. 2. Splitting wedge is dull. 3. Splitting wedge is damaged. 1. Don’t attempt to split unsuitable logs. 2. Sharpen wedge. 3. Stop operations/repair wedge. Ram does not retract properly. 1. Debris lodged in the ram