Now is a good time to clean and inspect the lenses also. If the lenses are in bad shape, a replacement set is recommended. MAN#650205 11. Push the bulb base plug and wire from the LED assembly through the light bulb hole in the back of the tail light housing. 12. While working the wire harness through the light bulb opening, place the LED assembly into the housing. The mounting plate is marked with up arrows that should point to the top of the tail light housing when the LED assembly is insta

Remove the original bulb sockets from the housing. 2. Remove the tail light housing hardware so the housing can be taken out of the car. Remove the housings from the vehicle carefully so the body gaskets are not damaged. 3. Next remove the lens to gain access to the housing. There are six screws that hold the housing halves together, remove the screws and separate the halves carefully. 4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Re

B Kit Includes: Installation: 1. Remove the two screws and tail light lens. 2. Remove the light bulb. 3. Push and twist to remove the plastic wire socket from the back side of the housing. 4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Remove the nut and round metal spacer from the back of the new LED assembly. MAN#650188 rev. B 6. Insert the new LED assembly through the hole where the original bulb and connector were. Use caution whe

2. Remove the tail light housing from the car. 3. Remove any body trim from the housing so the screws holding the lens on are exposed. 4. Remove the tail light lens. 5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 6. Remove the lock nuts and aluminum back plate from the back of the new LED assembly. 7.Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoi

2. Remove the light bulb 3. Remove the original bulb connector from the back side of the housing. 4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Remove the two screws and mounting plate from the side of the new LED assembly. 6. Insert the new LED assembly into the taillight housing and route wires through the hole where the original bulb and connector were located. Use caution when feeding the wires through to avoid damaging the wire

A Kit Includes: Installation: 1. Remove the original bulb connector from the back side of the housing. 2. Remove the tail light housing from the vehicle. 3. On the Chevelle, remove the chrome tail light cover. There are four nuts on the back side of the housing. 4. Remove the tail light lens. On the Camaro there are five screws and one metal clip on the back side of the housing. 5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 6. Remove th