Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
1. This product is intended for use with bare bulb instruments pointed straight down. Refer to the light manufacturer’s recommendations before operating the light in this position. 2. Do not leave unattended. 3. Use the light’s protective screen or shield at all times. 4. Use in a moderate temperature environment. 5. Open the Lantern’s flaps for ventilation as required. 6. Maximum power capacity for this product is 400 watts. ASSEMBLING THE FRAME The frame has three components. The first consists of four lengths of curved wire attached to a small metal ring. The second consists of four aluminum tubes with tapered tips on one end and tubular inserts on the other end. (A fifth tube is included as a spare.) The third consists of the Speed Ring for the light you intend to use. (Speed Ring sold separately) 1. Hold the curved wire component by the metal ring and allow the wires to hang loose. This will permit the wires to fall into order (photo 1). 2. Insert the loose end of one of the outside wires as far as it will go into the tapered end of the tubular component (photo 2). 3. Insert the other end of the tubular component into one of the mounting holes on the outside corners of the Speed Ring (photo 3). 4. Assemble the remaining poles in the same manner and insert them in order in the remaining mounting holes in the Speed Ring (photo 4). Photo 1 Photo 2 Photo 3 Photo 4 1812 Valtec Lane, Boulder, CO 80301 303-444-8000 888-444-1812 fax 303-444-8303 sales@chimeralighting.com 18609800/030101 1 PLACING THE LANTERN BODY ON THE FRAME 1. Open all four zippers on the top of the Lantern body. 2. Turn the Speed Ring vertically with one pole pointed up. 3. Align one of the corner seams in the Lantern body with the upward-facing pole (photo 5). 4. Pull the body over the pole until the curve in the pole fits in the curve in the body. 5. Pull the rest of the body over the remaining poles. The last corner assembled will go on tighter than the others corners. 6. Close the zippers on top of the Lantern (photo 6). 7. The fully assembled Lantern will appear as in photo 7. 8. Attach the assembled Lantern to the light fixture. 9. Attach the light fixture to a light stand or boom arm. Photo 5 Photo 6 Photo 7 MOUNTING THE SKIRT ON THE LANTERN 1. Unzip one of the corner zippers in the Skirt from top to bottom. 2. Wrap the Skirt around the Lantern, making sure the corners are aligned. 3. Align the hook-and-loop strips on the Skirt with the hook-and-loop strips on the Lantern and press the two together (photo 8). 4. Zip up the open zipper (photo 9). 5. Adjust the Skirt as desired by unzipping the corner zippers from bottom to top and rolling up the sides (photo 10). Photo 8 Photo 9 Photo 10 1812 Valtec Lane, Boulder, CO 80301 303-444-8000 888-444-1812 fax 303-444-8303 sales@chimeralighting.com 2 18609800/030101 SMALL PANCAKE LANTERN ASSEMBLY INSTRUCTIONS Item numbers 1860 and 1864 REMOVING THE BODY FROM THE FRAME 1. Allow the light to cool. 2. Remove the Skirt from the Lantern...
Эта инструкция также подходит к моделям:Прочие аксессуары для дома - 1864 (73.28 kb)