Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
water pressure Recommended hot water temp. Max. hot water temp Hole size - spout Hole size - valve Max. mounting surface depth Flow rate -- 17104/17105 only Flow rate -- all other models Terrano 37135XX1 14.7 - 72.5 psi 147 psi 120° - 140° F* 176.F* 1-3/8" 1-1/4" see diagrams 1.5 gpm max. 2.2 gpm max. Requires 1/2" hot and cold supply hoses -- not included Installation Considerations • For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber. • Please read over these instructions thoroughly before beginning installation. Make sure that you have all tools and supplies needed to complete the installation. *Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. Installation Starck only Remove the valve mounting nuts from the valves. Push the valves up into the holes. Install the mounting nuts on the valves. Tighten the tensioning screws. Place the handles over the valve mounting nuts. Tighten the handles by rotating the escutcheons clockwise. The handles should be parallel to the basin. Install the spout Position the sealing ring, escutcheon, and spout on the mounting surface. Install the mounting flange. Thread the collar onto the stud and tighten. Screw the connection hoses into the mounting angle. Connect the mounting angle to the spout tube using the 10 mm compression fitting. The metal side of the compression ferrule must face up toward the spout. Turn to page 10 to continue the installation. Install the hot and cold valves Install the mounting nut, metal washer and the fiber washer on the valve. Insert the valve through the hole in the deck. Install the stop ring on the valve. Install the mounting flange. The stop ring will stop it at the proper height. Rest the valve on the mounting surface. Turn the valve so that the outlet points toward the center. Tighten the mounting nut. Tighten the tensioning screws. Installation – Carlton, Phoenix, Terrano, and Steel Carlton, Phoenix, and Steel only Install the handle escutcheons. Carlton, Phoenix, and Terrano only Position the handle over the valve stem. Rotate the lower part of the handle clockwise so that it threads down over the valve. Terrano 37135XX1 only Place the spout and sealing ring on the mounting surface. Install the friction washer, fiber washer, and nut. Tighten the tensioning screws. Install the spout Carlton only Place the spout and sealing ring on the mounting surface. Install the mounting flange. Thread the collars onto the studs and tighten. Steel only Install the color rings: red on the left and blue on the right. Install the handle snap connectors. Position the handle over the valve. Push it firmly into place on the snap connector. Steel only Position the spout, escutcheon and sealing ring on the mounting surface. Install the mounting flange. Thread the collar onto the stud and tighten. Terrano 37136XX1, Phoenix only Position the spout and sealing ring on the mounting surface. Install the mounting flange. Thread the collar onto the stud and tighten. Install the connecting hoses Push a 3/8" compression nut and ferrule over the end of the connecting hose. Push the end of the hose into the valve outlet. Tighten the compression nut wrench...
Эта инструкция также подходит к моделям:Прочие аксессуары для дома - Allegroh 36135XX1 (2.8 mb)
Прочие аксессуары для дома - Carlton 17125XX1 (2.8 mb)
Прочие аксессуары для дома - Carlton 17235XX1 (2.8 mb)