Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
Above Toekick or Adjust to Oven Installation Height28-1/2" 2" Min. Allow 5/8" Overlap onAll Sides30" 10-1/2" 23-1/4" 23-1/2" Min. InsideOven Cutout9-1/4" 2x2 or 2x4Anti-Tip BlockAgainst RearWall, 9" FromFloor to Bottom ofBlock9" 298Dia1226" Including Handle23-1/4" 30" 10-1/2"9" 1" DrawerOpen27" 9" 2x4 or 2x2Runners or Solid BottomInstall2x4 or 2x2Anti-Tip Block Against Rear Cabinet Wall9" From Floor to Bottomof Block298Dia16 Double Oven Installation (in inches) 298Dia1328-1/2" 2" Min. Allow 5/8" Overlap onAll Sides30" 10-1/2" 23-1/4" 23-1/2" Min. Inside1" Min. Above Toekick Oven Cutout2x2 or 2x4Anti-Tip BlockAgainst RearWall, 9" FromFloor to Bottom ofBlock9" 9-1/4" Note: Additional clearance between cutouts may be required. Check to be sure that oven supports above the Warming Drawer location do not obstruct the required interior 23-1/2" depth and 9-1/4" height. R Listed by Underwriters Laboratories For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000. Specification Revised 10/05 130716 Monogram.“ ZTD910BF/SF/WF – GE Monogram 30" Warming Drawer Undercounter Installation (in inches) ElectricalOutlet 16" Max. From Left SideInstallation Belowa Drawer23-1/2 Min. Solid Barrier1/4Air Gap251-1/2 Cabinet Top36CountertopHeight1 Min.* 28-1/29-1/4Electrical Outlet 42" Max. From Right Side Install a Solid BarrierBelow a CooktopSee NoteElectrical OutletFlush With Sideof Cabinet 7" Max. 9Install2x4 or 2x2Anti-Tip BlockAgainst RearCabinet Wall9" From Floorto Bottomof Block7Install a Solid Barrierand a 1/4" Air GapAbove Warming Drawer Note: When installing warming drawer with a cooktop, allow a 2" minimum from cooktop burner box bottom to top of cut-out. Important Installation Note: Must provide anti-tip brace at the back of the cabinet and at the top of the cutout. Optional Accessories: ZXD30B – 3/4" wood panel trim kit * Note: When installing the warming drawer below a cooktop, a solid barrier must be installed at 1" from the lowest point of the bottom of cooktop burner box to the top of cutout. Use any solid material such as 1/4" thick plywood. Allow at least 1/4" air gap between the barrier and the top of the warming drawer. See label on top of the warming drawer for approved cooktop models. 2Min. Side to Side Installation • When installed, the front face of the drawer will be nearly flush with adjacent cabinetry doors. • Drawer overlaps will conceal cut edges on all sides of the opening. The rough opening for the drawer must be: –Depth 23-1/2" min. from inside back to front of cabinet frame. –Width 25-1/2" for 27" wide models, 28-1/2" for 30" wide models. –Height 9-1/4" • 5" min. above floor or 1" above toekick. 23-1/4" from floor to bottom of cutout is recommended for under countertop installation. Installation below a cooktop: Warming drawers are approved for installation below only certain specified cooktop models. See the label attached to the top of the warming drawer for approved models. A solid barrier and air gap between cooktop and warming drawer is required. See Note above. Installation below a cabinet drawer: The warming drawer may be installed beneath a cabinet drawer. In this installation, a solid barrier should be installed above the warming drawer to block access. Use any solid material such as 1/4" thick plywood. Allow at least 1/4" air gap between the barrier and the top of the warming drawer. Observe the 5" min. above the floor or 1" above the toekick minimum installation height. Note: If you are installing in frameless cabinets, it may be necessary to install 1/2" wide cleats to accept drawer mounting screws. See drawer to find exact locations of mounting screws. Side to Side Installation: Install two warming drawers in separate cutouts. Allow 2" min. between cutouts. R Listed by Underwriters Laboratories For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000. Specification Revised 10/05 130716 Monogram.“ ZTD910BF/SF/WF – GE Monogram 30" Warming Drawer ZTD910WB Features and Benefits • 1.92 cu. ft. Capacity • Variable Temperature Control – Proof (80)/ Low (140)/Med (170)/High (210) • Variable Humidity Control – Crisp to Moist • Half Rack • “On” Signal Light • On/Off Rocker Switch • Removable Stainless Steel Pan • Full Extension Ball Bearing Glides • Hidden Controls Provide Flush Installation Appearance • Variable Installation Options • Pan Set Included • Model ZTD910WFWW – White on white • Model ZTD910BFBB – Black on black • Model ZTD910SFSS – Stainless steel Specification Revised 10/05 130716 ...