Оценок - 2, средний балл: 5 ( )

Производитель: Broan Размер: 2.14 mb Название файла: Язык инструкции:

Consider where the compactor will be installed and determine whether to hinge the door on the left or right side of the cabinet. Since the hinge pins are permanently attached to the door pan, simply rotate the door pan until the hinge pins are on the desired side. You may want to mark the inside of the door pan to indicate the top. 4. To prevent damage to the actuator on the back of door, remove the (2) screws that hold it in place. Save the actuator and screws. For wood door: 5. The wood door pan is designed to accommodate a .” thick wood panel that is 14-7/8” wide by 29-1\4” tall. It is recommended that you verify the height of the door pan prior to cutting the wood panel to size. Center the door pan on the wood panel and fasten together using hardware provided in the compactor parts bag. For tile door: 5. The tile door pan comes preassembled with cement backer board. Tile and grout the door pan using traditional tiling methods and materials. 6. Purchase a door handle to match your cabinet hardware and install per handle instructions. 7. If the door will be hinged on the left side of the compactor, it will be necessary to reverse the lower hinge bracket removed in Step 1. Remove the plastic bushing from the hinge bracket and install on the opposite side of the bracket. Install the door onto the compactor cabinet by reversing the procedure from Step 1. 8. Re-install the actuator removed in Step 4. Make sure the door opens and closes smoothly with the actuator entering and exiting the door interlock switch on the compactor. cap bushing door 6. Being careful not to scratch the door, remove the plastic door bushing and cap from the top and bottom of the door using a small flat screwdriver. Install the bushings on the side of the door panel that will be hinged and install the cap on the opposite side. 7. Install the door on the cabinet by inserting the upper hinge pin into the upper door bushing while moving the door into place. Insert the lower hinge pin from Step 1 and tighten securely. back of door actuator Tile and Wood Door Assembly Use the following instructions if you have a trash compactor with a tile or wood door kit. It is recommended you remove the door pan from the compactor to install the custom tile or wood panel. To remove door pan: 1. Use a 3/16” allen wrench to remove the lower hinge bracket from the cabinet (2 screws). 2. Remove the door pan from the cabinet. door lower hinge bracket bushing screws door pan lower hinge bracket screws Start Button (with Ram Status LED) Door Interlock Interlock Actuator Key Lock Compact Mode Switch Bag Storage Area Preparation Odor Disk Ram Compaction Plate Release Tab Compaction Plate Trash Bucket Latches (2) Sliding Trash Bucket Leveling Rollers Leveling Legs 1. how the compactor works The Broan compactor compresses household trash up to 1/6 of its original volume. It will compact normal household trash including milk cartons, glass and plastic bottles, containers and jars, tin cans, wrappings, boxes, food wastes, etc. When you start the compactor, an electrically powered ram moves down into the trash bucket, compresses the trash and then returns to the “UP” position and shuts off automatically. NOTE: The ram travels about 2/3 of the way down into the trash bucket. Because of this, the trash bucket must be at least 1/3 full before you will notice any compression. ModeOnNormalHold Compact ModeOnNormalHoldCompact ModeOnNormalHold 2. uSE OF key lock switch The key lock switch on your compactor is provided for your protection as a safety measure. When the key lock switch is in the “OFF” position, the compactor will not operate. Lock your compactor, and remove the key to keep children from operating the unit or to prevent anyone from tampering with it. When the key lock switch is in the “ON” position, the compactor is ready for operation. The key cannot be removed when in the “ON” position. NOTE: Opening the door during operation will stop the unit. If the compactor is stopped during its cycle, it will always move back UP when the door is closed. Preparation 4. iNSTALL Bag With the door open and the trash bucket extended to the furthest position, place a bag into the bucket. Fold the bag over the top rim of the bucket, on all sides. Press the bag into all corners of the bucket and smooth the bottom. Smooth and shape the bag carefully - this will prevent the bag from being torn by the ram during compaction. Secure the bag in place over the 2 buttons on each side of the bucket. The bag has prepunched slots for this purpose. 3. INSTALL odor control disk Your Compactor is equipped with an odor control disk that will last up to six months when installed in the trash compactor. The odor disk comes packaged in a foil pouch and is activated once the pouch is opened. Write dates on the odor disk labels in this manner: • When pouch is opened, write the “Activation Date” on top of disk in space provided. • Write dates on the GREEN month indicator labels in this manner: Month...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: