Оценок - 3, средний балл: 4.3 ( )

Производитель: APW Wyott Размер: 1.98 mb Название файла: Язык инструкции:

CAUTIONMETALPARTSOFTHISEQUIPMENTBECOMEEXTREMELYHOTWHENINOPERATION.TOAVOIDBURNS, ALWAYSUSEHANDPROTECTIONWHENOPERATINGTHISAPPLIANCE. The Alto-Shaam heated display case is intended for use in commercial establishments by qualified operating personnel where all operators are familiar with the purpose, limitations, and associated hazards of this appliance. Operating instructions and warnings must be read and understood by all operators and users. START-UPOPERATION BEFORE INITIAL USE: Interior display case surfaces must be heated toremove surface oils and the accompanying odorproduced during the first use of the appliance. Remove pans. Turn thermostats to the “ON” position. Set thermostats to the 10 setting. Allowthe unit to heat for 30 minutes or until no odor is detected. PREHEATING: The unit should be preheated at the 10 settingfor a minimum of 30-45 minutes before loadingthe case with hot food. Follow the operatinginstructions indicated on the next page ofthis manual. D A N G E R DISCONNECT UNIT FROM POWER SOURCE BEFORE CLEANING OR SERVICING. DANGERATNOTIMESHOULDTHEINTERIOROREXTERIORBESTEAMCLEANED, HOSEDDOWN,ORFLOODEDWITHWATERORLIQUIDSOLUTIONOFANYKIND.DONOTUSEWATERJETTOCLEAN. SEVEREDAMAGEORELECTRICALHAZARDCOULDRESULT. WARRANTYBECOMESVOIDIFAPPLIANCEISFLOODED HN2 & HN2SYS Series Operation & Care Manual • 7 OPERATINGINSTRUCTIONSOPERATINGINSTRUCTIONS OPERATINGPROCEDURES 1. DO NOT ADD WATER TO DISPLAY CASE Halo Heat display cases maintain a constant butgentle temperature and eliminate much of themoisture loss associated with conventional display cases. Because of this gentle heat, it is not necessaryto add water to the display case. As a matter of fact, adding water is not recommended since water will accelerate the deterioration of the product, and maydamage the unit voiding the warranty. 2. PLACE DIVIDERS AND SERVING PANS IN CASE Refer to the pan layout diagrams for differenttypes of pan accommodations. A complete panconfiguration layout is located in this manual. It is VERY important to note, no matter what typeof pan configuration chosen, pan separator barsor divider bars must be used to close all gapsbetween pans, and all gaps between the pansand the edges of the display case. If these gapsare not closed, heat will escape from the bottom ofthe case into the display area. As a consequence, heat distribution will be uneven and uniform temperature will be difficult to hold. If needed, additional pan divider bars are available. The supplied self-serve pan inserts with wire grids arefor use with pre-packaged foods in the self-servesections of the units. 3. TURN DISPLAY LIGHTS “ON” AND SET THE THERMOSTAT(S) AT NUMBER “10” TO PREHEAT A indicator light will illuminate when thethermostat(s) is (are) turned “ON.” The indicator(s) will remain lit as long as the unit ispreheating or calling for heat. The unit should be preheated at the 10 setting for a minimum of30-45 minutes before loading the case with hotfood. When preheating is completed, or wheneverthe un...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: