Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8 sheet metal screws, two on each side. 3. Seal the ice maker to the top of the dispenser as follows: (Flush with rear and left side) A. Apply beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so that the ice maker sets on the RTV. B. Set the ice maker onto the lid and position it as required. C. Wipe away any excess RTV. 4. Remove the left rear screw (only) installed in Step 2. Use that screw to install the mounting bracket (item 2) and install the cover (item 9) to the rear of the dispenser and the ice maker. Drill 9/64” diameter holes into the ice maker cabinet using the bracket as a template. Use extreme caution not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using the screws provided. Release Date: November 10, 2010 Revision: B © 1998-2010, IMI Cornelius Inc. - 1 - Publication Number: 620911301 “K” Style Lid Kit Installation Instructions 5. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the bin thermostat, if so equipped or required. CAUTION: Bin thermostat must not interfere with agitator rotation. 6. Place the lid (item 4) in position over the stainless steel flange and install the thumb screw (item 7). W\ CAUTION: The back of the ice maker must be flush with the back of the lid (item 1 ). Publication Number: 620911301 Figure 1. - 2 - © 1998-2010, IMI Cornelius Inc....
Эта инструкция также подходит к моделям:Прочая кухонная техника - 15303 (379.12 kb)