Оценок - 1, средний балл: 5 ( )

Производитель: Samsung Размер: 8.09 mb Название файла: Язык инструкции:

b When the machine is successfully connected to the wireless network, the WPS LED light stays on. Connecting in PIN mode The network configuration report, including PIN, must be printed. 1 In ready mode, press and hold the (Cancel or Stop/Clear) button on the control panel for about 5 seconds. You can find your machine’s PIN number. Press and hold the (WPS) button on the control panel for more than 2 4 seconds until the status LED stays on. The machine starts connecting to the access point (or wireless router). You need to enter the eight-digit PIN within two minutes on the 3 computer that is connected to the access point (or wireless router). The LED blinks slowly for up to two minutes until you enter the eight- digit PIN. The WPS LED blinks in the order below: a The light blinks fast on the WPS LED. The machine is connecting to the access point (or wireless router). b When the machine is successfully connected to the wireless network, the WPS LED light stays on. Re-connecting to a network When the wireless function is off, the machine automatically tries to re-connect to the access point (or wireless router) with the previously used wireless connection settings and address. In the following cases, the machine automatically re-connects to the wireless network: • The machine is turned off and on again. • The access point (or wireless router) is turned off and on again. 2. Using a Network-Connected Machine 156 Wireless network setup Wireless network setup Canceling the connection process To cancel the wireless network connection when the machine is connecting to the wireless network, press and release the (Cancel or Stop/Clear) button on the control panel. You need to wait 2 minuites to re-connect to the wireless network. Disconnecting from a network To disconnect the wireless network connection, press the (WPS) button on the control panel for more than two seconds. • When the Wi-Fi network is in idle mode: The machine is immediately disconnected from the wireless network, and the WPS LED is off. • When the Wi-Fi network is being used: While the machine waits until the current job is finished, the light blinks fast on the WPS LED. Then, the wireless network connection is automatically disconnected. The WPS LED is off. Using the menu button Before starting, you will need to know the network name (SSID) of your wireless network and the network key if it is encrypted. This information was set when the access point (or wireless router) was installed. If you do not know about your wireless environment, please ask the person who set up your network. After completing the wireless network connection, you need to install a machine driver to print from an application (see "Installing driver over the network" on page 141). Select (Menu) > Network > OK > Wireless > OK > WLAN Settings 1 > OK on the control panel. Press the OK to select the setup method you want. 2 • Wizard: The wireless network interface card in your machine searches for wirel...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: