Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Before servicing the TV, follow these guidelines: • Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. • Remove replacement components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection. • Always hold components by their edges. Avoid touching the edge connectors. Never slide components over any surface. • Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare metal part of your workbench or other grounded connection. • Touch a bare metal surface on your workbench or other grounded object before touching any components. Rear Cover Removal Lay TV flat on workbench. Be careful to protect the front bezel and LCD screen from being scratched. Use protective cloth between work bench and TV front. Note: Before disassembly of any part the TV, make sure the power is OFF, and the power cord is removed from the wall outlet. Allow time for power within all system boards to discharge before you begin disassembly. Never insert any objects into the vent holes in the TV case. Stand Removal (1) Lay TV flat on workbench. Be careful to protect the front bezel and LCD screen from being scratched. Use protective cloth between work bench and TV front. (2) Remove screws in the sequence indicated below (1 thru 6). (3) Remove stand. *NOTE: Pictured is a 26” model. 32” and 37” models will have different stand screw quantities and locations. Rear Cover Removal (4) Remove control box cover screws (PIC1 item 1, 2) (5) Remove control box cover screws (PIC1 item 3) (6) Remove control box cover- slide toward bottom of TV and lift off. (7) Lift up the control box from the A/V connector side (PIC1). There are cables underneath that are connected so be careful. Release control box from back hinges and tilt to the left (PIC3). (8) Tear off the Aluminum foil covering the LVDS connector. Disconnect LVDS cable connector from LCD panel (PIC2). (9) Disconnect the LCD Panel power cord from bottom side of control box (PIC3). Note: Before returning this product to the end user, you must follow the steps outlined in the section, Before Returning This Product to the User, on page 19. This procedure ensures that the chassis will not cause electric shock. Rear Cabinet Cover LCD Panel and Front Bezel Note: Before disassembly of any part the TV, make sure the power is OFF, and the power cord is removed from the wall outlet. Allow time for power within all system boards to discharge before you begin disassembly. Never insert any objects into the vent holes in the TV case. Note: OEM LCD panels were used in production. The following LCD panel disassembly/removal instructions may not apply to all models. Ensure LCD panel is completely detached from the bezel before removing so the bezel is not damaged. (1) Remove screws (PIC1) in the sequence of 1, A. (2) Remove screws (PIC1) in sequence of 2, 3, 4, B, C, D (3) Remove screws which fasten rear cabinet to front frame (PIC1) in the following sequence: A..B..C..D..E..F then 1..2..3..4..5 (4) Remove rear cabinet cover. Only the rear cabinet cover will come off. *NOTE: Pictured is a 26” model. 32” and 37” models will have some different rear cabinet cover screw quantities and locations. (5) Remove screws from TV stand support fra...
Эта инструкция также подходит к моделям:Принтеры - FLM-2632 (2.56 mb)
Принтеры - FLM-2632M (2.56 mb)
Принтеры - FLM-2634B (2.56 mb)
Принтеры - FLM-3232 (2.56 mb)