Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
• Ensure that the snap buttons fully protrude through their respective adjustment holes. • Check leg tips for rips, tears, cracks or wear. If any of these conditions exist, replace leg tips IMMEDIATELY. • Users with limited physical capabilities should be supervised or assisted when using the shower chair. • The shower chair is not to be used as a transfer bench, transfer device or climbing device. • Exercise caution when assembling the chair to avoid pinching. • After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware and parts are secure. • Ensure that all four chair legs are adjusted to the same height, and that all height adjustment buttons protrude fully through adjustment holes before use. • ALWAYS observe the weight limit on the labeling of your product. Check that all labels are present and legible. Replace if necessary. ACCESSORIES WARNING • Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products. Shower Chair Models DETAIL “A” - MODEL 91-2 AND 96-2 MODEL DESCRIPTION WEIGHT LIMITATION 91-2 Shower Chair 315 lb (143 kg) 96-2 Shower Chair with Back 315 lb (143 kg) 9981 Folding Shower Chair with Back 250 lb (114 kg) 9785-1 9785-2 Bariatric Shower Chair with Back Bariatric Shower Chair with Back 700 lb (318 kg) 700 lb (318 kg) Snap Button Back Support Tubes Assembling the Shower Chair Leg Extension NOTE: Not all procedures apply to all chair types. Refer to the chair type to verify if the procedure applies before attempting any procedure. NOTE: For this procedure, refer to FIGURE 1. DETAIL “B” - MODEL 9785-1 AND 9785-2 •For models 96.2 (DETAIL “A”) or 9785.1 and 9785.2 (DETAIL “B”): Back Support Tubes Back Support Brackets Leg 1. Put the shower chair on its side on a flat, stable surface. 2. Pressthesnapbuttonsonthebacksupporttubesandslidethe back support tubes into the back support brackets on the leg frame until both snap buttons are fully engaged inside the holes in the back support brackets. NOTE: Two audible “clicks” will be heard. Installing/Adjusting the Leg Extensions NOTE: For this procedure, refer to FIGURE 1 and FIGURE 2. FIGURE 1 Assembling the Shower Chair 1. Install the leg extension onto the leg (FIGURE 1). 2. Press the snap button and slide leg extension up or down to Leg Extension desired adjustment hole (FIGURE 2). 3. Ensure the snap button protrudes fully through the adjustment holes of the leg extension. Height Adjustment NOTE: There will be an audible click when the snap button fully engages. Holes 4. Repeat STEPS 1 .3 for the other legs. Snap Button NOTE: Make sure that all four legs are adjusted to the same height. Snap Button Back Support Brackets FIGURE 2 Installing/Adjusting the Leg Extensions For more information regarding Invacare products, parts, and services, please visit Pa...
Эта инструкция также подходит к моделям:Принадлежности для ванной - 96-2 (819.27 kb)
Принадлежности для ванной - 9785-1 (819.27 kb)
Принадлежности для ванной - 9785-2 (819.27 kb)
Принадлежности для ванной - 9981 (819.27 kb)