|
Фрагмент инструкции
Put the shower chair on its side on a flat, stable surface. 2. Pressthesnapbuttonsonthebacksupporttubesandslidethe back support tubes into the back support brackets on the leg frame until both snap buttons are fully engaged inside the holes in the back support brackets. NOTE: Two audible “clicks” will be heard. Installing/Adjusting the Leg Extensions NOTE: For this procedure, refer to FIGURE 1 and FIGURE 2. FIGURE 1 Assembling the Shower Chair 1. Install the leg extension onto the leg (FIGURE 1). 2. Press the snap button and slide leg extension up or down to Leg Extension desired adjustment hole (FIGURE 2). 3. Ensure the snap button protrudes fully through the adjustment holes of the leg extension. Height Adjustment NOTE: There will be an audible click when the snap button fully engages. Holes 4. Repeat STEPS 1 .3 for the other legs. Snap Button NOTE: Make sure that all four legs are adjusted to the same height. Snap Button Back Support Brackets FIGURE 2 Installing/Adjusting the Leg Extensions For more information regarding Invacare products, parts, and services, please visit Part No 1145752 1 Shower Chairs Unfolding and Folding the Shower Chair NOTE: This procedure applies to shower chair model 9981 only. NOTE: For this procedure, refer to FIGURE 3. 1. Place the shower chair on the floor/tub floor in the uprightposition. 2. Pull on the top edge of the inside leg to unlock the pivot stopbracket from the recess in the underside of the seat (Detail “A”). 3. Lift up on rear edge of seat. NOTE: When folding the shower chair, the pivot stop bracket MUST beflipped up BEFORE the pivot stop bracket can lock into the recess (Detail“B”). 4. Grab the top of the inside leg and pull towards the rear of theseat until stopped by the pivot stop bracket (Detail “C”). 5. Lower the rear edge of the seat so that the top of the inside legfits securely into the groove along the back edge of the seat(Detail “D”). WARNING Ensure the top of the leg tube is fully inserted and seated in the seat groove before using this device. DETAIL “A” Pivot Stop DETAIL “B” Bracket Seat Inside Leg (Top) Rubber Tip Seat Recess DETAIL “C” DETAIL “D” Seat Inside Leg (Top) Groove Seat Pivot Stop Inside Bracket Leg Pivot Stop (Top) Bracket Rubber Tips 6. If necessary, push the backrest into position (Detail “E”). DETAIL Cleaning “E” Backrest NOTE: Before using any cleaning products, test an area on the bottom of NOTE: Foldingshower chair with the shower chair to make sure the product does not cause discoloration or Seat backrest shown. staining. DO NOT use an abrasive detergent or cleaner to clean the shower chair. FIGURE 3 Unfolding and Folding the Shower Chair Use a water and a mild, non.abrasive cleaner to clean the shower chair. Limited Warranty Invacare warrants this product to be free from defects in materials and workmanship. PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warran...
Эта инструкция также подходит к моделям:Принадлежности для ванной - 91-2 (819.27 kb)
Принадлежности для ванной - 9785-1 (819.27 kb)
Принадлежности для ванной - 9785-2 (819.27 kb)
Принадлежности для ванной - 9981 (819.27 kb)