Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Place one side of panel under side trim and bow slightly until other side fits under opposite trim. Slide panel(s) up to fit under control panel. 4. Replace bottom trim by fitting slot over bottom edge of door and secure by pressing from one side to the other. Customized Wood Panels Some models can be customized with 1/4” wood panels. Refer to your installation instructions for more information. Control Panel Color Panel(s) Bottom Trim Bottom Edge of Door Changing Color Panels (continued) Solutions to Common DishwashingProblems Before calling for service, review this list. It may save you bothtime and expense. This list includes common experiences that are not the result of defective workmanship or material in your dishwasher. Food Soils Left on Dishes • Choose another cycle for longer washing time. • Check rack loading section for proper loading—avoid nesting items. • Home water pressure may be too low—should be 20 to 120 pounds per square inch (psi). • Check incoming water temperature. It should be at least 120°F (49°C). (See Factors Affecting Performance.) • Check water hardness. For extremely hard water, it may be necessary to install a water softener. (See Detergent Chart.) • Use fresh detergent. • Check to make sure tower in lower rack is not blocked. • Make sure items are not blocking the spray arm, preventing it from rotating. • Check to see if the liquid rinse aid dispenser needs refilling or if the solid rinse aid needs replacing. Dishes not Dry • Select Hot Dry option. • Make sure the liquid rinse aid dispenser is filled. Check container to see if it is time to replace solid rinse aid. • Increase the amount of rinse aid, if available on your model. (See Rinse Aid). • Check the incoming water temperature. Be sure it is at least 120°F (49°C). • Check for proper loading— avoid nesting items. • Plastic items may need to be towel dried. • Cups with a concave bottom will collect water. Glassware/Flatware Spotted or Cloudy • Check water hardness. For extremely hard water, it may be necessary to install a water softener. (See Detergent Chart.) • Water temperature may be low. Avoid extremely low or high temperatures. (See Factors Affecting Performance.) • Avoid overloading and improper loading. (See Preparing and Loading Dishes.) • Use fresh detergent. Old detergent is ineffective. • Check to see that proper amount of detergent is being used. Also, check phosphate level. (See Detergent Dispenser.) • Home water pressure may be too low—it should be 20 to 120 pounds per square inch (psi). 17 Solutions to Common Dishwashing Problems (continued) Dishware Chipped • Load with care and do not overload. (See Preparing and Loading dishes.) • Place delicate items in top rack. • Place glasses securely against pins and not over pins. • Load items so they are secure and don’t jar loose when moving racks in and out. Move racks in and out slowly. • Make sure tall glasses and stemware will clear top of tub when rack is pushed in. • Fine antique china and crystal should be hand-washed. Dishware Stained or Discolored • Tea and coffee can stain cups. Remove the stains by hand washing in a solution of 1/2 cup (120 ml) bleach and one quart (1 L) of warm water. Rinse thoroughly. • Iron deposits in water can cause a yellow or brown film. A special filter installed in the water supply line will correct this problem. (See Removing Spots and Film.) • Aluminum utensils can leave gray/black marks when they rub against other items. Load properly. • Certain high acid foods can cause discoloration of stainless steel and plastics if allowed to sit for a long period. Rinse by hand if not operating dishwasher at once. • Mixing stainless steel and silver utensils in silverware basket can cause pitting of the stainless steel blades. Avoid mixing stainless steel and silver. Etching • Using too much detergent in soft or softened water causes this film that cannot be removed. • Adjust the amount of detergent based on the water hardness. (Check Detergent Chart.) • Lower the water temperature. • Use the Cool Dry option. Detergent Left in Cups • Detergent may be old. Discard and use fresh detergent. • Be sure water action can reach the dispenser. • Check to see if cycle has been completed. • Make sure items do not prevent the detergent dispenser from opening. 18 Solutions to Common Dishwashing Problems (continued) Dishwasher Leaks • Use only fresh detergent designed for automatic dishwashers. Measure detergent carefully. Try a different brand. • Spilled rinse aid can cause foam and lead to overflowing. Wipe up any spills with damp cloth. • Check to see that dishwasher is level. (See Installation Instructions.) Normal Sounds You Will Hear • Normal sounds include water fill, water circulation and motor sounds. Water in Bottom of Tub • Water left in bottom of tub after cycle is complete is not normal. If water remains in the bottom of the tub, dishwasher may not be draining properly. (See Dishwasher Does Not Drain Properly.) Vapor at Vent • Water vap...
Эта инструкция также подходит к моделям:Посудомоечные машины - F71C12 (829.49 kb)