Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
This will release any accumulated hydrogen gas. HYDROGEN GAS IS FLAMMABLE. Do not smoke or use an open flame during this time. • Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. SAVE THESE INSTRUCTIONS ©2000 White Consolidated Industries, Inc. All rights reserved. Printed in U.S.A. 2 3 Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces. Each cycle begins with a pre-drain. Next, the dishwasher fills with water covering the filter area. Water is then pumped through the filter and spray arms. Soil particles go down the drain as the water is pumped out and replaced with clean water. The number of water fills will vary with the cycle being used. Dishwasher Features Serial Label (located on right side of tub) Bottom Rack page 8 Heating Element page 11 Glass Trap page 11 Self-Cleaning Filter page 11 Tub Gasket page 11 Lower Spray Arm pages 8,12 Overfill Protector page 11 Top Rack page 7,8 Funnel pages 7,8,12 Middle Spray Arm pages 7,8,12 Detergent Dispenser page 9 Nozzle and Upper Spray Prewash Detergent Cup page 9 Rinse Aid Dispenser page 10 Vent pages 4,6,13 Operating Instructions Vent Latch Vent Latch Very Important Information—Read Before Operating Your Dishwasher! Normal Operating Sounds This dishwasher does not sound like most dishwashers—IT'S QUIETER. Your Precision Wash System® dishwasher uses energy efficient motors for the wash and drain portions of the cycle you select. Each cycle has a series of water fills and drains for washing and rinsing dishes. As each cycle begins, you may–or may not– hear the drain motor. The next sound you will hear is the splashing water as it enters the tub. Then the lower arm rotates and circulates water. This is followed by a pause and a slightly different sound as the middle arm sprays water. If you listen closely, you will hear the change in sound as the wash action switches from one arm to the other. PLEASE BE ADVISED: If you compare this dishwasher to previous models, you may be surprised at what you DON'T hear! Appearance may vary from your model. Getting Started 1. Load dishwasher (See Preparing and Loading Dishes). 2. Add detergent (See Dishwasher Dispenser & Detergents). 3. Add rinse aid, if needed (See Rinse Aid). 4. Close door to latch. 5. Select desired CYCLE (See Cycle Chart). The indicator light above the pad will glow when selected. 6. Select desired OPTIONS (See Energy Options). The indicator light above the pad will glow when selected. 7. Run hot water faucet nearest dishwasher until water is hot. Turn water off. 8. To start, press START/CANCEL pad. Note: The dishwasher is programmed to remember your last cycle so you do not have to reset each time. To start the dishwasher using the same cycle and options selected on the previous wash, just press the START/CANCEL pad. Wash Cycle Selections Note: Cycle times are approximate and will vary with options selected. Hot water is necessary to activate dishwasher detergent and melt fatty food soils. An automatic sensor will check the incoming water temperature and, if it is not hot enough, the timer will be delayed for automatic water heating in the main wash of all cycles. This happens even when HI-TEMP WASH option has not been selected. When HI-TEMP WASH is selected, an even higher temperature will be guaranteed to handle heavier soil loads. 4 Operating Instructions (continued) Cycle Chart Cycle To Select Cycle Water (approx.) Time* (min.) Washes/ Rinses For pots, pans, casseroles and dinnerware with dried-on or baked-on soils. Pots Pans Select POTS PANS and desired OPTIONS. HI-TEMP WASH and SANITIZE will automatically be provided. gal. imp. gal. liters 8.5 7.1 32.2 105 2 washes 5 rinses For regularly soiled dishes and silverware. Normal Wash Select NORMAL WASH and desired OPTIONS. gal. imp. gal. liters 6.1 5.1 23.1 85 2 washes 3 rinses For lightly soiled and pre-rinsed dishes and silverware. Light Wash (Both Racks) Select LIGHT WASH (BOTH RACKS) and desired OPTIONS. gal. imp. gal. liters 4.9 4.1 18.5 75 1 wash 3 rinses For lightly soiled and pre-rinsed dishes and silverware when you do not have a full load. Light Wash (Upper Rack) Select LIGHT WASH (UPPER RACK) and desired OPTIONS. gal. imp. gal. liters 3.7 3.1 14.0 65 1 wash 2 rinses * Includes dry time. Options Selections Hi-Temp Wash When HI-TEMP WASH option is selected, the dishwasher heats water in the main wash to approximately 140°F (60°C). This increase in water temperature helps dishwasher detergent remove food grease and soil from dishes more effectively and aids in drying. HI-TEMP WASH option can be used with all cycles. When HI-TEMP WASH option is selected, the light above the pad will come on and remain on until end of cycle. To turn off the HI-TEMP WASH option, press the pad a second time. The light above the pad will turn off. Sanitize Option To sanitize your dishes and glassware, select the SAN...
Эта инструкция также подходит к моделям:Посудомоечные машины - 800 (1016.15 kb)
Посудомоечные машины - 800 (1016.15 kb)
Посудомоечные машины - 800 (1016.15 kb)
Посудомоечные машины - 800 (1016.15 kb)