Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
limescale deposits are formed. Any problems which arise as a direct result of the use of these products are not covered by our warranty. aus Programme overview This overview lists the max. possible number of programmes. The programmes supplied with your appliance are indicated on the fascia. Type of crockery e.g.china, pots/pans, cutlery, glasses, etc. Type of food remains Amount of food remains Condition of food remains Wash programme Programme sequence Programme details Duration in minutes with heat exchanger Electricity consumption in kWh with heat exchanger Water consumption in litres with Aquasensor Nondelicate Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot very little stuck on hard Auto 55°.65° Intesive 70° Eco 50° Quick 35° Pre-rinse Rinse-aid 70° Drying Drying Drying Main rinse Main rinse Rinse-aid 55° Wash 35° Rinse-aid 65° Wash 50° Laboratory measured value in accordance with European Standard EN 50242 Rinse off if the dishes have been stacked for several days in the dishwasher prior to washing. Pre-rinse Mixed Normal/ Delicate Mixed Glass 40° Rinse-aid 50° Drying a little loosely attached Third rinse Pre-rinse 50° Wash 70° First rinse Second rinse medium The programme sequence isoptimized and adapted with howthe appliance is loaded and howdirty the dishes are. Pre-rinse First rinse Second rinse Wash 40° Pre-rinse Pre-rinse Soups, potatoes, pasta, rice, eggs, roast or fried food Coffee, cakes, milk, sausage, cold drinks, salads 112 1,60 21 18 140 1,05 14 – 135 0,65 19 – 30 0,60 10 – 19 0,10 4 – 95–145 1,15–1,50 11–19 – aus Washing dishes Reduce costs! If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Programme data The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e.g. temperature, water volume, ...). Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. Aquasensor The Aquasensor is an optical measuring device with which the cloudiness of the water in the dishwasher is measured. A photoelectric sensor is used to detect the degree of soiling in the water, caused by dissolved food particles such as egg, fat and rolled oats, etc. The Aquasensor functions during all programmes that include a pre-rinse cycle. If the water is still “clean” at the end of the pre-rinse cycle, then the same water is used for the following wash cycle. If the water is dirty, it is pumped out of the dishwasher and replaced by fresh water. The effect is to reduce water consumption by approx. 4 litres when the dishes are only “slightly” dirty. Switching the dishwasher ON Turn on the tap. Set main switch 1 to ON. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 6 is pressed The numerical display 4 shows the expected duration of the programme. Close door. The programme starts automatically. End of programme The end of programme is indicated by a buzzer. This function can be changed as follows: Hold down the Time delay programme button and switch on the Main switch 31 , then release the buttons. The Time delay button 3 flashes and the digital display indicates the value (loud) which was set at the factory. To change the setting: Press the Time delay programme button 3 . Each depression of the button increases the set value by one; when is reached, the display jumps back to (off). Switch off the Main switch 1 . The set value is stored in the appliance. Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended. Set main switch 1 to OFF. Turn the water tap off. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. aus Interrupting the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until the spray arm has stopped rotating. Set main switch 1 to OFF. Indicator lights extinguish. The programme is retained in the dishwasher memory. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may fly open due to expansion. In order to continue with the stored programme, set the main switch to ON again and close the door. Programming the timer You can delay the start of a programme in increments of one hour for up to 19 hours. Switch dishwasher ON. Immediately press the TIMER button 3 . The numerical display 4 changes to . Press the TIMER button as many ...
Эта инструкция также подходит к моделям:Посудомоечные машины - SGU59A05AU/20 (2.34 mb)
Посудомоечные машины - SGU59A05AU/21 (2.34 mb)
Посудомоечные машины - SGU59A05AU/22 (2.34 mb)