Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
How to Use the Lower Rack We recommend that you place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. -Pots, serving bowls, etc. must always be placed top down. -Deep pots should be slanted to allow the water to flow out. - Silverware should be placed in the silverware basket with the handles at the bottom; If the rack has side baskets, the spoons should be loaded individually into the appropriate slots (see fig. A) Especially long utensils should be placed in the horizontal position at the front of the upper rack. How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). - Position the dishes and cookware so that they do not get moved by the spray of water. How to adjust the Upper rack ... The top rack can be adjusted using the two rack heights (top and bottom). To adjust the rack, open up the tabs that lock the guides and pull out the rack. Arrange the rack with the back wheels in either the top or bottom position and then insert it along the guides until the front wheels are on as well. Close the tabs to lock the rack in place (see Fig. F) Load examples Top Rack Top Rack Lower Rack Lower Rack Fig. A 1 2 3 4Fig. F 5 GB Turning on the Appliance Starting a wash cycle.... After having completed all of the installation steps in the preceding paragraphs, turn on the water to the unit and press the ON-OFF button (A) located on the control panel. The "B" indicator light will come on. At this point, the appliance is on and ready to be programmed. Starting and selecting the cycle. Turn the cycle selector knob "D" until the reference notch on the knob corresponds with the number or the symbol for the cycle you wish to set (have a look at the wash cycle table on page 7). After a few seconds, you will hear a short beep and the indicator light “G” comes on, indicating that the wash cycle has begun and it is not advisable to make any changes at this point. Cycle phase indicator lights The dishwasher is provided with 4 indicator lights "G" which come on in sequence as the appliance is performing that specific phase of the wash cycle. These phases are, from left to right: pre-wash, wash, rinses, drying Cancelling or modifying a wash cycle in progress….. Premise: You can cancel the wash cycle in progress, if it has only just started. To modify a wash cycle in progress, turn the knob anti- clockwise and set it to Reset, after a few seconds you will hear 4 beeps and indicator light "G" will go out: this means all the settings have been cancelled. You are now free to reset the correct wash cycle. If you forget to load some of the dishes... The wash cycle can be interrupted by pressing the ON-OFF. You can then load additional dishes and turn the appliance back on. The cycle will start where it left off. At the end of the wash cycle…. The end of the wash cycle is signalled by 2 short beeps and a flashing drying phase indicator light “G”. Set the knob to the Reset position to clear all settings. Turn the appliance off by pressing button "A", thus cutting off the electricity supply. Turn off the water tap. Wait a few minutes before unloading the dishes: they are very hot! If you wait a little while, they dry better thanks to the steam. Empty the lower rack first. Make sure the wash cycle has ended before removing the dishes! There's been a power failure? Have you opened the dishwasher door? The wash cycle stops and then restarts when the electricity comes back on or when you close the door. Warning If opening the door soon after the end of the programme,or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. GB 6 Wash Cycle Table Cycle Cycle selection instructions Cycle description Detergent for prewash + wash Rinse Aid 1) Heavy Duty Very dirty dishes and pans (not to be used for delicate items). Pre-wash with cold water Pre-wash with hot water at 45°C Extended wash at 70°C. Cold rinse Rinse with hot water at 70°C. Drying. 5+15 gr. * 2) Normal wash Normally dirty pans and dishes. Standard daily cycle. 2 pre-washes with cold water. Extended wash at 55°C. Rinse with hot water at 70°C. Drying. 5+15 gr. * 3) Rapid 25’ Economic and fast cycle to be used for slightly dirty dishes. Run cycle immediately after use. No drying. Short wash at 45°C. Cold rinse. 15 gr. 4) Soak Preliminary wash cycle for dishes and pans awaiting completion of the load with the dishes from the next meal. Short cold wash to prevent food from drying onto the dishes. 7 GB Energy Saving Tips -It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from c...