Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Installation requirements
Gas requirements
Special gas requirements (gas models sold in massachusetts)
Provide adequate gas supply
COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS:
This range is designed to operate at a pressure of 5 in (13 cm) of water column on
WARNING
natural gas or 10 in (25 cm) of water column on LP gas (propane or butane).
Gas leaks may occur in your system, creating a dangerous situation.
Make sure you are supplying your range with the type of gas for which it is
• Gas leaks may not be detected by smell alone.
designed. Do not attempt to convert the appliance from the gas specified in this
• Gas suppliers recommend you purchase and install a UL-approved gas detector.
manual to a different gas without consulting the gas supplier.
Gas detector should be installed in accordance with the manufacturers
This range is convertible for use on natural or propane gas. If you decide to use
instructions.
this range on LP gas, conversion must be made by a qualified LP installer before
• Range must be installed by a qualified plumber or gas fitter by the State of
attempting to operate the range.
Massachusetts.
For proper operation, the pressure of natural gas supplied to the regulator must be
• A T-handle manual gas valve MUST be installed in the gas supply line to your
between 5 in and 13 in (13 cm and 33 cm) of water column.
range.
Ins
• If a flexible gas connector is used to install your range, multiple flexible gas
For LP gas, the pressure supplied must be between 10 in and 13 in (25 cm and
t
allation r
lines must not be connected in series.
33 cm) of water column.
When checking for proper operation of the regulator, the inlet pressure must be at
Electrical requirements
least 1 in (2.5 cm) greater than the operating (manifold) pressure as given.
equir
WARNING
The pressure regulator located at the inlet of the range manifold must remain in
ement
the supply line regardless of whether natural or LP gas is being used.
To reduce the risk of fire, electric shock, or personal injury:
A flexible-metal appliance connector used to connect the range to the gas supply
All ranges
s
line should have an I.D. of 0.5 in (1.3 cm) and be 5 ft (152 cm) in length for ease of
installation. In Canada, flexible connectors must be single-wall metal connectors no
• Do not use an extension cord or adapter plug with this range.
longer than 6 ft (183 cm) in length.
• This range must be properly grounded.
• Check with a qualified electrician if you are in doubt as to whether your range
Do not kink or damage the flexible metal tubing when moving the range.
is properly grounded.
• Do not modify the plug provided with your range—if it doesn’t fit the outlet,
have a proper outlet installed by a qualified electrician.
• All wiring and grounding must be done in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA No. 70 –
Latest Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1 – Latest
Revisions and local codes and ordinances.
16 English
...