Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Do not cut corners. Serious complications and possible safety risks may occur. Always use a certified installer. This installation is not recommended FIREPLACE INSERT INSTALLATION CONTINUED…… The MagnuM Countryside Model 3502 Fireplace Insert requires a fireplace shroud for proper installation. The shroud is designed to slip over the stove-top between the front and back hopper lids. Shrouds can be customized for particular installations (custom order). 1) Position unit so that the shroud can be slid over the top lid behind the sliding draft control knob (located on the left side of the unit). Alternate Method: Open the back lid, slide shroud over sides, slide onto front lid, close back lid, slide onto back lid. 2) Attach 3” flex pipe connector to the 3” exhaust tube on the back of the unit. Allow enough flex pipe to pull the unit out of the fireplace opening for maintenance but be careful not to crimp pipe when pushing insert into place. 3) You may silicone around the fireplace shroud connecting it to the stove or leave the shroud loose for easy removal during vent cleaning. This will have to be done after pushing unit into place. Be sure to route the stove plug-in-cord through the shroud before pushing the unit into place. PERIODIC MAINTENANCE At least once a year the chimney and smoke chamber must be inspected and cleaned. The fireplace insert will have to be removed for the purpose of inspecting the fireplace insert and the chimney. The buildup of fly-ash in the chimney pipe will cause the unit to operate inefficiently. Continued use will cause malfunction of the unit. Venting should be checked at least monthly 42” 29” To Remove the Fireplace Insert: Disconnect the power supply, slide the insert forward leaving the shroud in place and being careful not to dislodge the chimney flex pipe, open the clean-out to empty the fly-ash, inspect chimney conditions and connections, clean as needed, slide insert back into place, make sure that all chimney connections are in place and then re-connect the power supply. It is important to do regular cleaning and maintenance to an insert as the venting is long and will build up with fly-ash. POWER CORD ACCESS Standard Shroud Your MagnuM Countryside Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with two (2) clips on the top and two (2) clips on the bottom REMOVAL OF BROKEN OR DAMAGED GLASS Open the door and lift off of hinges. If the door is tight, tap gently on the bottom of the door with your hand or rubber hammer. Lay door down on newspaper with glass clips facing you. Using a #2 Phillips screwdriver, loosen the screws and take off the glass clips. Remove the broken glass carefully and discard. Check to make sure that the gasket material under the glass is in good shape. You can get this material from the factory or from an authorized MagnuM Countryside dealer if it needs to be replaced. Reverse the above procedure for replacing new glass. When installing the new glass make sure that the glass is not sitting on top of any obstruction. The glass will break when tightening the screws if the glass is on the gasket. Hold the glass toward the top of the door glass channel when tightening. CLEANING THE GLASS When the fire is first started, it will produce some smoke. The smoke might accumulate on the glass surface. Before the fire gets hot, open the door and wipe the glass surface off with a damp rag. Do not touch the surface with your hands. If after constant use, the glass is dirty; you must clean the glass so that it will not become etched with the fly-ash. When the glass has cooled off, take a damp rag, put a little fly- ash from the unit on it and clean the glass. If this does not clean the glass use a special glass cleaner provided by your MagnuM Countryside dealer. We have found that Amway creme glass & chrome cleaner works real well. GLASS MAINTENANCE, ADJUSTMENT, REMOVAL AND REPLACEMENT WARNING Do no operate unit with broken glass. Do not substitute original factory glass. You must use only factory authorized glass: (811/16” x 15 1/8” high temperature Ceramic glass, 5mm thick) Do not slam door shut. Do not strike glass. Do not use abrasive cleaners. Do not clean when glass is hot. Glass Hold Down Clip (4) Front view Left view Side view showing control operation Adjustable Air Deflector Move up or down to adjust air direction Adjustable Door Handle lifts up and turns to the left to open Sliding heat exchanger tube cleaning rod. Pull in and out to clean heat exchanger tubes. Adjustable hinges. Loosen locking nut and move in or out to adjust. Pedestal Ash Pan (3500P & 3500L models) Turn (2) knobs counter clockwise to open ash pan door, pull out ash pan (be sure to wear gloves) and empty into a metal sealed container. Make sure that the ash pan area is clean before putting the ash pan back into place. Close ash pan door and turn k...
Эта инструкция также подходит к моделям:Плиты - 3500L (3.3 mb)