Войти:
Оценок - 2, средний балл: 3.5 ( )

Инструкция по эксплуатации Metra Electronics, модель 99-7339B

Производитель: Metra Electronics
Размер: 409.36 kb
Название файла: INST99-7339S.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


THE WORLD’S BEST KITS.™ 1-800-221-0932 Q © COPYRIGHT 2007-2010 METRA ELECTRONICS CORPORATION 99-7339 TABLE OF CONTENTS Dash Disassembly - Hyundai Genesis Coupe 2010..............................1 Kit Preparation -HyundaiGenesis Coupe2010.............................. .2 Kit Assembly - ISO DIN Head Unit Provision................................3 *Note: Refer also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians. 99-7339 DASH DISASSEMBLY HYUNDAI GENESIS COUPE 2010 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the shifter trim panel. (Figure A) 3 Unclip and remove the radio/climate control trim panel. (Figure B) 4 Unclip and remove the display trim panel above radio. (Figure C) 5 Remove (4) Phillips screws securing the radio. 6 Remove (4) Phillips screws securing the climate control to the factory trim panel. A C 1 99-7339 KIT PREPARATION KIT PREPARATION HYUNDAI GENESIS COUPE 2010 1 Attach the climate control to the 957336S trim plate using the factory hardware. (Figure A) 2 Attach the (6) panel clips to the 957336S trim plate. (Figure B) A Continue to kit assembly 2 99-7339 KIT ASSEMBLY HYUNDAI GENESIS COUPE 2010 ISO DIN HEAD UNIT PROVISION 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2 Attach the ISO brackets to the aftermarket radio (figure A), then secure the assembly to the pocket using the (4) supplied Phillips screws (figure B). 3 Mount the assembly into the sub dash. 4 Reassemble dash in reverse order of disassembly using the 99-7339 trim panel instead of the factory trim panel. A В 3 99-7339 INSTRUCTIONS METRA. THE WORLD’S BEST KITS.™ Q 1-800-221-0932 Q REV. 12/15/09 ©COPYRIGHT 2003-2010 METRA ELECTRONICS CORPORATION INST99-7339...

Эта инструкция также подходит к моделям:
Плиты - 99-7339S (409.36 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории