Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Monthly Your Miracle Steamer utilizes an open steam generator. Water sprayed onto the generator surface flashes into steam immediately, but the minerals in the water do not steam, they stay on the generator surface. A small amount of mineral deposits are needed for proper operation, but a build-up of excessive mineral deposits causes poor steaming efficiency, excessive moisture (wet steam) and will eventually severely retard the steaming action completely. Cleaning Steam Generator 1. Turn the rocker switch (power on/off) to OFF. Unplug the power cord and allow the unit to cool down before proceeding. 2. Remove top cover from unit. 3. Remove wing nut and generator cover (Figure 8). 4. Remove the diffuser. CAUTION Do not use a sanitizing solution or abrasive materials. The use of these may cause damage to the stainless steel finish. CAUTION If a chemical cleaner is used, be sure it is safe to use on cast aluminum. Observe all precautions and warnings on product label. 12 P/N 1010699 Rev. B MIRACLE STEAMER P/N 1010699 Rev. B 13 A.J. Antunes & Co. 11. Clean unit surface with a hot, clean, damp cloth (not dripping wet) and wipe dry. 12. Re-install all parts and fasten the generator cover. NOTE: To ensure proper steaming characteristics, some mineral deposits must be present on generator casting. If during cleaning, the casting does become free of mineral deposits, add plain tap water to casting and allow to boil off. NOTE: In soft water areas, it may be necessary to add a small amount of lime to generator to “season” it. This will ensure proper steaming characteristics by producing a thin coating of mineral deposits on the casting. Seasoning mixture consists of 2 ounces (59.15 milliliters) baking soda, 2 ounces (59.15 milliliters) lime mixed with 2 ounces (59.15 milliliters) of warm tap water. Pour the seasoning mixture into the bowl portion of the generator, turn the steamer rocker power (on/off) to ON. Once the mixture has boiled off, remove the remaining loose powder. 13. Plug in power cord and water line (if applicable). Figure 8. Miracle Steamer Components READY ADDADD WATERWATER Spatula (MS-150/250 only) Liner (MS-150/250 only) Drip Pan (MS-155/255/355 only) Liner (MS-155/255/355 only) Drawer (MS-155/255/355 only) Top Cover Wingnut Cover Diffuser Steam Vent MS-355 Shown 5. Examine all generator orifices (holes). If mineral deposits have formed, place a flat blade screwdriver into openings. Use a gentle twisting motion to scrape openings clean. NOTE: If the mineral deposits come off in “flakes” or in layers, build-up is excessive. 6. Use a brass or stainless steel wire brush to remove deposits from the generator surface. 7. Pour a delimer solution (not supplied) onto the generator surface and allow to soak for one hour. Be sure to follow the delimer manufacturer’s directions for proper mixture and use. NOTE: Use only a Aluminium safe de-liming product. 8. Remove the delimer solution from the generator and rinse with clear water to remove traces of delimer. 9. Clean the following parts in hot detergent water, then rinse in clear water and allow to air dry: • spatula/drawer • top cover • liner • steam vent • generator cover • diffuser 10. Clean steam chamber of any product spills. A.J. Antunes & Co. MIRACLE STEAMER Water Filters–Models MS-150/155 To prevent solids or food products from entering the water pump, the unit uses two water filters (Figure 9). Inspect and clean (if necessary) these filters monthly using the following procedure: 1. Turn the rocker switch (power on/off) to OFF. Unplug the power cord and allow the unit to cool down before proceeding. 2. Remove access cover and tank assembly. 3. Drain water from access cover/tank assembly by sliding tank assembly cover open, tip assembly and pour water into a container or sink. 4. Remove top filter located inside the tank by pulling it out (Figure 9). 5. Remove bottom filter located in water tank outlet tube by disconnecting the hose from the outlet and removing filter (Figure 9). 6. Clean filters by running them under tap water. Replace them if they are torn or damaged. 7. Install bottom filter inside the water outlet tube. Install outlet hose and clamp. 8. Install top filter into water outlet tube inside the tank. 9. Install access cover and tank assembly. 10. Fill water tank and test unit. NOTE: The MS-355 does not use a water filter. Direct water hook-up Units (MS-250/255) Use of the optional water regulator kit, part no. 7000235, is recommended (see page 25). Top Water Filter Bottom Water Filter Figure 9. Water Filters–MS-150/155 14 P/N 1010699 Rev. B A.J. Antunes & Co. MIRACLE STEAMER TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Problem Possible Cause Corrective Action Unit will not heat up. Rocker (power on/off) switch...
Эта инструкция также подходит к моделям:Пароварки - MS-355 (880.78 kb)