Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Power connection requirements Multi pole circuit breaker and all pole disconnection isolator switch installed near the appliance. Supply line voltage; 400-415V ~ 50Hz, 3P+N+E Special voltage options available on request. Power Connection Total (kW) 31 Convection power (kW) 30 Rated Current (A) (400V) 45 IPX5 spray-proof and hose proof. Installation clearances - rear 25mm - right 500mm* - left 50mm *Clearance required on fixed installations for service accessibility. If heat sources are located near the RH side of the AC combi, ensure that a minimum distance of 400mm is maintained. Install in accordance with local body regulations only on horizontal surfaces and not against combustible walls. Water connection requirements - Cold water -Flow pressure (2 to 6 bar) -soft water connection* -shut-off valve with return flow inhibitor and dirt filter -water supply R3/4 -R50 waste water connection (*Water softener may be required. Please refer to installation manual for water treatment values.) In line with policy to continually develop and improve its products, Moffat Limited reserves the right to change specifications and design without notice. TECHNICAL SPECIFICATION SHEET FOR BLUE SEAL ELECTRIC COMBI STEAMER AC SERIES E20AC DD 20 x 1/1GN or 10 x 2/1 A = WATER CONNECTION R3/4 (SOFTENED WATER) refer to installation manual for water treatment values. B = WATER CONNECTION R3/4 C = DRAIN CONNECTION O60 D = ELECTRICAL CONNECTION ENTRY E = HIGH/LOW PRESSURE RELIEF VENT F = OVEN VENT O80 Optional Extras SC Core temperature probe SPT20 Stainless steel stand with 12 x 1/1 or 6 x 2/1 GN shelves to suit 20AC DD SST20 Removable rack complete with fitting frame alternative to side runners to suit 20AC DD TLT20 Removable frame for oven and plate racks to suit 20AC DD SGT20 Removable oven rack to suit 20AC DD PRT20 Plate banquet rack to suit 20AC DD / 60 plates CRT20 Trolley for removable oven rack with drip tray to suit 20AC DD CPT20 Thermal cover for plate banqueting system to suit 20AC DD KP004 Set of four legs for bench mounting ...