Do not expose the battery to water. Do not expose the battery to heat. Do not store in locations where the temperature may exceed 40°C. Charge only at ambient temperatures between 4°C and 40°C. Charge only using the chargers provided with the tool. When disposing of batteries, follow the instructions given in the section "Protecting the environment". 11 ENGLISH Chargers Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the ra

Inspection and repairs Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation. The following safety symbols are marked on your spotlight: Warning! To reduce the risk of injury, the user must read the instruction manual. Warning! Do not touch the lens as it becomes very hot during operation and remains hot for several minutes after the spotlight is switched off. Warning! Burn hazard. Ho

Inspection and repairs Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation. The following safety symbols are marked on your spotlight: Warning! To reduce the risk of injury, the user must read the instruction manual. Warning! Do not touch the lens as it becomes very hot during operation and remains hot for several minutes after the spotlight is switched off. Allow the spotlight to f

Make any needed repairs or replacement before using on the reel, 4, UNPLUG ANY TOOLS OR APPLIANCES CONNECTED TO THE CORD REEL BEFORE REELING. 5, Always plug the Cord Reel into an approved, grounded 120 volt receptacle. (Even if you plan to use only Double Insulated tools or appliances.) 8, Check the cord periodically for damage and have damaged cords replaced immediately. 7, Keep your Cord Reel out of the reach of children. 8, Store your Cord Reel in a cool, dry place out of direct sunlight

Knowing how to properly use the cord reel will prevent you from having problems such as jams or uneven winding. © A. Lay the cord reel flat on the ground near an electrical outlet. The handle should be turned toward you. CAUTION When directed to do so, pull the cord simultaneously from both sides! Do not pull on the plug (male) end of the cord without pulling on the socket end. B. Simultaneously pull the cord from both sides of the cord reel until the plug will reach the outlet. If you do n

Warning! Never attempt to replace the charger unit with a regular mains plug. Use your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. Have defective cords replaced immediately. Do not expose the charger to water. Do not open the charger. Do not probe the charger. The spotlight must be placed in a well ventilated area when charging. All batteries lose charge with time, specially when they a

Sliding the switch forward (toward the Spotlight bulb) sets the Spotlight on High Beam; sliding the switch backward sets the Spotlight on Low Beam. Using the Carry Handle as a Stand For Hands-Free Operation Invert the unit to use the Carry Handle as a stand, and set it upon a flat, stable surface for hands-free operation. Using the Built-In Carry Lanyard The Carry Lanyard may be used to store or carry the Spotlight; and also allows you to position the Spotlight for convenient, hands-free operati

• To reduce risk of damage to plug and cord, pull • Use of improper extension cord could result in • Use only the supplied chargers when charging this spotlight or create a hazardous condition. • Use only one charger when charging. • Do not attempt to charge the unit if the charger plug is damaged— • Do not attempt to open the charger. There are no customer serviceable parts inside. Return to manufacturer for repair. • All ON/OFF switches should be in the OFF position when the unit is switches a

• DON’T OVERREACH. Keep proper footing and balance at all times. • DISCONNECT APPLIANCE. The AC Charger and DC Charging Adapter should be maintained in a readily operable condition. To avoid damage to the unit or Adapter, disconnect the unit from any power supply when not in use, before cleaning, during lightning storms, and changing accessories or when it will be unused for long periods of time. To disconnect the unit from the power supply, the AC Charger must be completely disconnected from an

Insert the S p o r t S p o t® spotlight 12 volt DC plug into the accessory socket of your vehicle or a portable 12 volt power source, such as a jump starter. 2 . To turn on the S p o r t S p o t® slide the spring-loaded power switch to the ON position (up). 3 . To turn off the S p o r t S p o t®, release the spring-loaded power switch. It will slide back to the OFF position (down). USING THE HANGING HOOK The Hanging Hook allows you to position the unit for convenient, hands-free operation. CAUTI