Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
,_, WARNING: Batteries vent hydrogen gas and can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately. ,_ WARNING: Never use a battery pack that has been damaged or received a sharp blow. A damaged battery pack is subject to explosion. Properly dispose of a damaged battery pack immediately. Failure to heed this warning can result in serious personal injury. • WHEN SERVICING USE ONLY IDENTICAL CRAFTSMAN REPLACEMENT PARTS. IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER Before using battery charger, road all instructions and cautionary markings in this manual, on battery charger, and product using battery charger. A CAUTION: To reduce the risk of injury, charge only nickel-cadmium type rechargeable batteries. Other types of batteries may burst causing personal injury and damage. Do not expose to wet or damp conditions. To reduce the risk of damage to charger body and cord, pull by charger plug rather than cord when disconnecting charger. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. That pins on plug of extension cord are the same number, size and shape as those of plug on charger. b. That extension cord is properly wired and in good electrical condition; and c. That wire size is large enough for AC ampere ratingof charger as specified below: Cord Length (Feet)-25' 50' 100' Cord Size (AWG) 16 16 16 Note: AWG = American Wire Gage • DO NOT OPERATE CHARGER WITH A DAMAGED CORD OR PLUG. If damaged, have replaced immediately by a qualified serviceman. • Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off controls will not red_Jce this risk. • Do not use charger in wet or clamp conditions. • Disconnect charger from power supply when not in use. SAVE THESE INSTRUCTIONS. Review them frequently and use them to instruct others who may use this light. If you loan someone this light, loan them these instructions also. SAVE THESE INSTRUCTIONS 3 BATI'ERYPACK/CHARGER • If both yellow and green LED come on, this indicates a deeply discharged or defective battery pack. Thebatterypackandchargerare not included with your worklight. They are both sold separately. When Allow battery pack to remain in charger for 15 to purchasing, use the following information: 30 minutes. When battery pack reaches normal MODEL NO. BATTERY PACK CHARGER voltage range, red LED should come on. 973.110470 Item No. _ 11375 Item No. 9 11041 If red LED does not come on after 30 minutes, this (1310715) (1425301 ) indicates a defective battery pack and should be BA'R'ERY PACK replaced. The battery pack for your worklight has been shipped • After normal usage, a minimum of 1 hour of in a low charge condition to prevent possible prob-charging time is required to fully recharge battery lems. Therefore, you should charge it until light on pack. front of charger changes from red to green. • The battery pack will become slightly warm to the Note: Batteries will not reach full charge the first time touch while charging. This is normal and does not they are charged. Allow several cycles (operating indicate a problem. worklight followed by recharging) for batteries to • Do not place charger and battery pack in an area become fully charged. of extreme heat or cold. It will work best at normal CHARGING BAT'rERY PACK room temperature. Note: Charger and battery pack should be placed See Figure Y. in a location where the temperature is more than Use only the recommended battery pack and 50°F but less than 100°F. charger with your worklight. • When batteries become fully charged, unplug Make sure power supply is normal household charger from power supply and remove the battery voltage, 120 volts, 60 Hz, AC only. pack. Connect charger to power supply. IMPORTANT INFORMATION FOR RECHARG- Place battery pack in charger aligning raised rib on ING HOT BA'I-rERY PACK battery pack with groove in charger. See Figure f. Press down on battery pack to be sure contacts on When using your worklight continuously, the batteries battery pack engage properly with contacts in charger. in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 Normally, the red LED on charger will come on. minutes before attempting to recharge. When the This indicates charger is in fast charging mode. battery pack becomes discharged and is...
Эта инструкция также подходит к моделям:Осветительные приборы - 11047 (722.42 kb)