Оценок - , средний балл: ( )

Инструкция по эксплуатации Daewoo, модель DHC-250

Производитель: Daewoo
Размер: 455.7 kb
Название файла:

Язык инструкции:

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Select a suitable location, making sure you have easy access to an electrical outlet. Plug the unit into a 115V~ 60Hz electrical socket-outlet with earth connection. Make sure the Water Tank is correctly fitted otherwise the unit will not operate properly. 1. Plug the cord to the proper power requirement. The computer system of the unit will have a self-check. If it is normal, the POWER indicator flashes at 0.5Hz. Press ON/OFF button now, the unit will start operating under DEHUMIDIFYING mode with 60% setting humidity. Press the HUMIDITY or button will change setting humidity. 2. Press the CONTINUE button will go into continues dehumidifying mode, and this time the HUMIDITY and button are disable. 3. Press the ON/OFF button to turn off the unit.(You do not meed to unplug the power cord except when the unit will not be in use for a long period of time.) OPERATING INSTRUCTIONS Turning the unit ON or OFF OPERATION Water Tank Water will drain into the tank. When the tank is full and the unit stops operating, the Water Full indicator light will flash. Do not remove the water tank whilst the machine is still working or just stopping. This might cause some water to drip. To empty the water tank, remove the tank as shown, empty the water and replace the tank back in the unit. Ensure components of water tank are correctly positioned. The machine will re-start when the water tank is restored in its correct position. 1. Drag out the bucket a little. 2. Hold the two sides of the bucket with even strength, and pull it out from the unit. 3. Pour the water out. 5 On the rear of the unit, remove the drain plug carefully (see picture below). Push the hose onto the connector located inside of the hole. The hose should go down smoothly without bends or kinks. Place the end of the hose into a suitable drainage facility. Continuous drainage MAINTENANCE Important: Be sure to unplug the unit before cleaning. Do not use petrol, thinners or other chemical agents to clean the unit as this may damage the unit. Do not wash the unit directly under a tap or hose. The electrical components inside may be damaged and the unit become unsafe as a result. Air filter ! Clean the air filter at least once every two weeks to prevent impaired performance of the unit. Pull the water tankt out as shown (Figure A), and pull the Air Filter down as shown (Figure B). Removal Cleaning Wash the air filter with clean water, and then carefully dry. Remove the drain plug Push the hose into the drain hole Attach the drain plug to the drain hole of the water tray. Note: Make sure the drain plug is completely inserted. 6 Fig. A Fig. B Fig. C Install the cleaned Filter following Figure C, and replace the water tank in the unit. Replacement Unit enclosure Use a soft, clean cloth to wipe the surface. Do not use water as this may cause an electrical fault or shock hazard. Water tank Wash the tank using warm water (about 40 ) with...