Войти:
Оценок - 2, средний балл: 3.5 ( )

Инструкция по эксплуатации Husqvarna, модель HUV4210-E

Производитель: Husqvarna
Размер: 1.45 mb
Название файла: HOUS2005_O0507004.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Completely open the fuel shut-off valve (Figure 17). Make sure the valve is fully open. A partially closed fuel shut-off valve (Figure 18) combined with the use of the choke can result in a fouled spark plug and engine failure. 4. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE. NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a short time when it is run for the first time after storage. 5. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 46. 6. Perform the Pre-Operation and Daily Safety Checklist on page 19. MAINTENANCE See General Warnings on page 9. To ensure trouble-free vehicle performance, it is very important to follow an established preventive maintenance program. Regular and consistent vehicle maintenance can prevent vehicle downtime and expensive repairs that can result from neglect. Use the Pre-Operation and Daily Safety Checklist on page 19 and the following Periodic Service Schedules and Periodic Lubrication Schedules to keep the vehicle in proper working condition. Any vehicle not functioning correctly should be removed from use until it is properly repaired. This will prevent further damage to the vehicle and avoid the possibility of injury due to unsafe conditions. Contact your local Husqvarna distributor/dealer to perform all repairs and semiannual and annual periodic service. y WARNING • If any problems are found during scheduled inspection or service, do not operate the vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death. • Only trained technicians should service or repair the vehicle or battery charger. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. The appropriate instructions must be used when performing maintenance, service, or accessory installation. Electric vehicles: • Hot! Do not attempt to service hot motor. Attempting to do so could cause severe burns. • To avoid unintentionally starting the vehicle, disconnect the batteries as shown (Figure 2, Page 11). • After disconnecting the batteries, wait 90 seconds for the controller capacitors to discharge. WARNING CONTINUED ON NEXT PAGE... Page 28 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Periodic Service Schedules y WARNING Gasoline vehicles only: • Moving parts: Do not attempt to service gasoline vehicle while the engine is running. • Hot! Do not attempt to service hot engine or exhaust system. Failure to heed this warning could result in severe burns. • Turn the fuel shut-off valve to the closed (OFF) position (Figure 16, Page 27). • To avoid unintentionally starting the vehicle, before servicing always disconnect the battery, negative (–) cable first (Figure 1, Page 11) and disconnect the spark plug wire from the spark plug. • Frame ground – Do not allow tools or other metal objects to contact frame when disconnecting batteries or other electrical wiring. Never allow a positive wire to touch the vehicle frame, engine, or other metal component. PERIODIC SERVICE SCHEDULES See General Warnings on page 9. y WARNING • Service, repairs, and adjustments must be made per instructions in the maintenance and service manual. NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventive maintenance procedure should be performed more often than recommended in the periodic service and lubrication schedules. Both the Periodic Service Schedule and Periodic Lubrication Schedule must be followed to keep vehicle in optimum operating condition. 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 29 Periodic Service Schedules PERIODIC SERVICE SCHEDULE – ELECTRIC VEHICLES REGULAR INTERVAL SERVICE Daily service by owner Batteries Charge batteries (after each use only). Weekly service by owner Batteries Check electrolyte level. Add water if necessary. See page 35. Monthly service by owner or trained technician Batteries Wash battery tops and clean terminals with baking soda/water solution. Tires Check air pressure and adjust if necessary. See Vehicle Specifications on page 46. General vehicle Wash battery compartment and underside of vehicle. Semiannual service by trained technician only (or every 50 hours of operation, whichever comes first) Brake system Check brake shoes; replace if necessary. See Section 6 – Wheel Brake Assemblies in the appropriate maintenance and service manual. Lubricate brake slides per Lubrication Schedule. See Section 6 – Wheel Brake Assemblies in the appropriate maintenance and service manual. Check brake cables for damage; replace if necessary. Electrical wiring and connections Check for tightness and damage. Forward/Reverse switch Check condition of contacts ...

Эта инструкция также подходит к моделям:
Оборудование к ТС - HUV4210-EXP (1.45 mb)
Оборудование к ТС - HUV4210-G (1.45 mb)
Оборудование к ТС - HUV4210-GXP (1.45 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории